Preliminary Draft, Not for Release - Please Review 2-3-2015
• Never throw a used battery in the trash. Promptly dispose of used batteries in accordance with local regulations.
• Do not short-circuit a battery or throw it into a fire; it can explode and cause severe personal injury. Do not allow metallic
conductive objects to contact battery terminals.
• If you observe that the Honeywell battery supplied is physically damaged, please send it to Honeywell International Inc.
or an authorized service center for inspection, see
• Battery usage by children should be supervised.
• Avoid dropping the terminal or battery. If the terminal or battery is dropped, especially on a hard surface, and the user
suspects damage, send it to a Honeywell International Inc. or an authorized service center for inspection.
• If you are not sure the battery or charger is working properly, send it to Honeywell International Inc. or an authorized
service center for inspection, see
• Excessive discharge can degrade battery performance. Recharge the battery when your terminal indicates low battery
power.
• Although your battery can be recharged many times, the battery life is limited. Replace it after the battery is unable to
hold an adequate charge.
• The Dolphin 75e should only be connected via its microUSB connector to CTIA certified adapters, products that bear the
USB-IF logo or products that have completed, the USB-IF compliance program.
System Resets
See
Resetting the Terminal
Hardware Maintenance
When needed, clean the image engine window and the touch screen with a clean, non-abrasive, lint-free cloth. The terminal can
be cleaned with a damp cloth.
Important: All battery and connector doors must be present, undamaged, and properly closed to maintain the environmental
rating of the terminal.
Installing a Memory Card
You can expand the terminal's memory capacity by installing a microSD or microSDHC card. Honeywell recommends the use of
Single Level Cell (SLC) industrial grade microSD or microSDHC memory cards with Dolphin terminals for maximum
performance and durability. Contact a Honeywell sales representative for additional information on qualified memory card
options.
Note: Format memory card before initial use.
Installation and/or Replacement
To install a memory card:
1. Power Off the terminal.
2. Unlock and remove the battery door.
Battery Door Lock
3 - 12
Product Service and Repair
on page 2-11.
Product Service and Repair
on page
14-1.
on page
14-1.