Filter Adjustment - Pioneer DEQ-P9 Owner's Manual

Audio Adjustment <Network>
Filter Adjustment <FTR> (Open state)
The following adjustments can be made during filter adjustments. Make the appropriate
adjustments for the reproduced frequency band and characteristics of the connected
speaker unit.
Filter frequency adjustment: Every 1/3 octave
Level adjustment: 0.5 dB/1 step
The cut-off frequencies of the high pass filter (H.P.F.) and the low pass filter (L.P.F.) of
each band (subwoofer, low, mid, high) and the reproduction level of each band are set up.
Range
Subwoofer-range
Low-range
Mid-range
High-range
Slope adjustment: PASS, –6 dB/oct. — –36 dB/oct. (Every –6 dB/oct., total of 6 steps)
The slope (inclination of attenuation of filter characteristics) of H.P.F. and L.P.F. is set up.
Note:
• When the slope is set as PASS, the audio signals bypass the filter circuit, cutting out the effect of
the filter circuit.
• In order to protect the speaker unit, H.P.F. has no PASS set up for high ranges.
• In order to protect the speaker unit, H.P.F. has no PASS set up for mid-range, however you can set
to PASS by changing the settings (refer to page 36, step 8).
Level (dB)
Level adjustment
33
Cut-off frequency
of H.P.F.
20 Hz — 100 Hz
25 Hz — 250 Hz
200 Hz — 10 kHz
1.6 kHz — 20 kHz
Reproduced frequency band: the signals for frequencies
0
20 100
Cut-off frequency of the L.P.F.
Cut-off frequency of the H.P.F.
Cut-off frequency
of L.P.F.
25 Hz — 250 Hz
250 Hz — 10 kHz
2 kHz — 20 kHz
8 kHz — 20 kHz
during += is reproduced.
Slope adjustment
1K 10K
Level adjustment
range
–24 — +10 dB
–24 — 0 dB
–24 — 0 dB
–24 — 0 dB
Frequency (Hz)