Page 3
Step 1: Install the Wi-Fi/Bluetooth card in a PCI Express x1 slot. Connect one end of the USB cable to the USB connector on the Wi-Fi/Bluetooth card. 步驟一: 先將Wi-Fi/藍牙卡安裝至PCI Express x1 插 槽,接著將USB排線的一端接至無線/藍 牙卡的USB連接埠插座。 步骤一: 先将Wi-Fi/蓝牙卡安装至PCI Express x1插 槽,接着将USB排线的一端接至无线/蓝 牙卡的USB连接端口插座。 ステップ...
Page 4
Step 2: Connect the other end of the USB cable to the F_USB connector on the motherboard. 步驟二: 再 將 U S B 排 線 的 另 一 端 接 至 主 機 板 的 F_USB插座。 步骤二: 再将USB排线的另一端接至主板的F_USB 插座。 ステップ 2: USB ケーブルのもう一方の端をマザー...
Page 5
Step 3: Tighten the antenna cables to the antenna connectors on the Wi-Fi/Bluetooth card respectively. 步驟三: 將天線鎖至Wi-Fi/藍牙卡的天線連接埠。 步骤三: 将天线锁至Wi-Fi/蓝牙卡的天线连接端 口。 ステップ 3: アン テ ナ ケ ーブ ル を そ れ ぞ れ W i - F i / Bluetooth カードのアンテナコネクターに しっかりと接続します。...
Page 6
Step 4: Then move the antennas to a place where the signal is good. 步驟四: 完成安裝後將天線移至收訊良好處。 步骤四: 完成安装后将天线移至收讯良好处。 ステップ 4: 次に、 ワイヤレス信号が受信し易い場所 にアンテナを配置します。 - 6 -...
Page 7
Installing the Drivers and Utilities • 安裝驅動程式及工具 安装驱动程序及工具 • ドライバとユーティ リティをインストールする After the computer starts, install the driver for the Wi-Fi/Bluetooth Card. Adjust your wireless LAN configuration based on your environment after installing the driver. 啟動電腦後請安裝Wi-Fi/藍牙卡驅動 程式。完成後即可依環境中的無線 網路選擇連接。 启动电脑后请安装Wi-Fi/蓝牙卡驱 动程序。完成后即可依环境中的 无线网络选择连接。...
Page 8
FCC Notice (U.S.A. Only) Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Page 9
Canada-Industry Canada (IC): This device complies with Canadian RSS-210. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Ce dispositif est conforme à...
Page 10
European Community Directive R&TTE Directive Compliance Statement: This equipment complies with all the requirements and other relevant provisions of Directive 1999/5/EC of the European Parliament and the Council of March 9, 1999 on Radio Equipment and Telecommunication Terminal Equipment (R&TTE). This equipment is suitable for home and office use in all the European Community Member States and EFTA Member States.
Page 12
GC-WB867D-I-L: Wireless Module Country Approvals/無線裝置國家/地區認證: See the latest safety and regulatory documents at: http://www.gigabyte.com/products/product-page.aspx?pid=4739...
Need help?
Do you have a question about the GC-WB867D-I and is the answer not in the manual?
Questions and answers