Juniper QFX5110 Hardware Manual page 145

Copyright © 2017, Juniper Networks, Inc.
System going down in 1 minute
*** System shutdown message from root@ ***
System going down in 30 seconds
*** FINAL System shutdown message from root@ ***
System going down IMMEDIATELY
Stopping cron.
Waiting for PIDS: 3494.
.
.
Waiting (max 60 seconds) for system process `vnlru' to stop...done
Waiting (max 60 seconds) for system process `bufdaemon' to stop...done
Waiting (max 60 seconds) for system process `syncer' to stop...
Syncing disks, vnodes remaining...0 0 0 0 0 done
All buffers synced.
Uptime: 3m26s
usbus0: controller did not stop
unloading fpga driver
Khelp module "jsocket" can't unload until its refcount drops from 5 to 0.
Rebooting...
cpu_reset: Stopping other CPUs
Consoles: serial port
BIOS drive C: is disk0
BIOS drive D: is disk1
BIOS drive E: is disk2
BIOS drive F: is disk3
BIOS 639kB/3144576kB available memory
CAUTION: The final output of any version of the
command is "The operating system has halted." Wait at least 60 seconds
after first seeing this message before following the instructions in Step
and Step 5 to power off the switch.
Attach the grounding strap to your bare wrist and to a site ESD point.
3.
Disconnect power to the switch by performing one of the following tasks:
4.
AC power supply—If the AC power source outlet has a power switch, set it to the
off (O) position. If the AC power source outlet does not have a power switch, gently
pull out the male end of the power cord connected to the power source outlet.
DC power supply—Switch the circuit breaker on the panel board that services the
DC circuit to the off position.
Remove the power source cable from the power supply faceplate:
5.
AC power supply—Remove the power cord from the power supply faceplate by
detaching the power cord retainer and gently pulling out the female end of the
power cord connected to the power supply faceplate.
Chapter 16: Removing the Device
request system halt
4
125