Installing and Removing the Battery
The battery is pre-installed to this product. If the battery is almost empty (see
EN
page 22), replace the battery with new one.
1.
Remove the battery cover of
the Speed & Cadence sensor.
Turn the cover counterclockwise with a
tool such as a coin or screwdriver, until
it stops turning.
2.
Remove the old battery.
20
3.
Install the new battery
(CR2032) and close the
battery cover.
Insert the battery with its (-) side facing
up and wait more than 3 seconds to
remove it. Then insert it with its (+) side
facing up. Doing this resets the sensor
so it operates reliably.
Then turn the battery cover clockwise
until it stops and is closed tightly.
•
Be careful not to lose the rubber
gaskets when removing the battery
cover.
Rubber
gaskets