Inserting Or Replacing The Batteries; Caresens N Blood Glucose Test Strip - i-SENS CareSens N POP Manual

Inserting or Replacing the Batteries

The CareSens N POP meter uses two 3.0 V lithium batteries.
Before using the meter, check the battery compartment and
insert batteries if empty.
When the symbol appears on the display while the meter
is in use, the batteries should be replaced as soon as possible.
The test results may not be saved if the batteries run out
completely.
Step 1
Make sure the meter is turned off.
Press down and slide off the battery
compartment cover.
Step 2
Remove the old batteries one by one by
lifting with the index finger and pulling it
out with your thumb and index finger as
shown in the diagram on the right. Insert
two new batteries with the + side facing up
and make sure the batteries are inserted
firmly.
Step 3
Place the cover on the battery
compartment. Push it down until you hear
the tab click into place.
Note: Removing the meter batteries will not affect your
stored results. However you may need to reset your meter
settings. See page 13.
8 www.i-sens.com

CareSens N Blood Glucose Test Strip

The CareSens N POP blood glucose monitoring system
measures blood glucose quickly and accurately. It automatically
absorbs the small blood sample applied to the narrow edge of
the strip.
Contact bars
Gently push the test strip, with its
contact bars facing up, into the test
strip port of meter
Insert
Confirmation window
Check here to see whether sufficient
blood sample has been applied
Edge to apply blood sample
Apply blood sample here for testing
www.i-sens.com 9