Disassembling The Paper Sensor - Olivetti NETTUNA 7000 Open Service Manual

DISASSEMBLING THE PAPER SENSOR

The operation described in this section can be displayed by clicking on the link:
To remove the paper detection sensor, proceed as follows:
1. Disassemble the printer assy. See
2. Press on the lever to raise the Clam as described in the section
ROLLER".
3. With a pair of pliers, extract the paper detection sensor (1) in the direction indicated by the arrow, being very
careful not to damage the printer roller.
Figure 4-15
4. Remove the connector for connecting with the motherboard.
To reassemble follow the same procedures in reverse order.
NOTE: after the Cash Register has been completely reassembled perform the printer unit photosensors calibration
using the Diagnostic Tool "
4-9
PAPER SENSOR DISASSEMBLY.MP4
"DISASSEMBLING THE PRINTER
DiagNettuna7000I 1.00.04.0.2
" or later version.
Service Manual
GROUP".
"DISASSEMBLING THE PAPER FEED
1
Y117850-4