Page 1
No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd. All other trademarks and trade names mentioned in this document are the property of their respective holders.
Table of Contents Getting to Know the UMG181....................... 1 PC Requirements ........................... 3 Preparing the UMG181........................4 Installation Guide........................... 5 Safety Information ......................... 8 12 MONTH LIMITED WARRANTY ....................15...
Stick. Note: This manual briefly describes the preparation, the process for installing/uninstalling, and safety precautions for using Huawei UMG181 HSPA Rotate USB Stick (hereinafter referred to as the UMG181). Read the manual before using the UMG181. Getting to Know the UMG181...
Page 4
Rotatable USB connector This is where the UMG181 connects to the USB interface of your PC. USIM/SIM card slot Open the lid to insert the USIM/SIM card in the slot. RF Output Power Port Connects the RF cable.
Indicates the status of the UMG181. Green, blinking twice every 3s: The UMG181 is powered on. Green, blinking once every 3s: The UMG181 is registered to a GSM/GPRS/EDGE network. Blue, blinking once every 3s: The UMG181 is registered to a WCDMA/HSDPA network.
PC. The following section takes Windows XP as an example. Connecting the UMG181 with a PC Note: Turn on your PC before connecting the UMG181 with it. Otherwise, the normal installation of the UMG181 may be affected. Method 1: Plug the UMG181 into the USB interface of the PC.
Page 8
Method 2:connect the UMG181 to a PC using the USB extension cable. Installing the UMG181 Management Program Connect the UMG181 with the PC. The OS automatically detects and recognizes new hardware and starts the installation wizard. Note: If the auto-run program does not respond, find the AutoRun.exe file in the driver path. Then...
Page 9
Select the hardware related to the UMG181 and click Stop. When the prompt "It is safe to remove the device" is displayed, remove the UMG181. In this way, the integrity of the data stored on the SD card can be ensured.
Regulatory Notices UMG181 complies with Parts 15, 22, and 24 of the FCC rules. It has been tested by using a typical PC with a USB port. This USB device must not be located or operated near any other antenna or transmitter.If you use this USB device in any other configuration, the FCC RF Exposure compliance...
Page 11
Acquisitions Regulations (FARs) Section 52.227-19 for civilian agency contracts or any successor regulations. If further government regulations apply, it is your responsibility to ensure compliance with such regulations. * WARNING: This product contains a chemical known to the State of California to cause cancer.
powder). Area indicated with the "Explosives" sign. Area indicated with the "Power off bi-direction wireless equipment" sign. Area where you are generally suggested to stop the engine of a vehicle. Traffic Security Observe local laws and regulations while using the wireless device. To prevent accidents, do not use your wireless device while driving.
in electrical and electronic equipment Directive 2002/95/EC (RoHS Directive). Laws and Regulations Observance Observe laws and regulations when using your wireless device. Respect the privacy and legal rights of the others. Care and Maintenance It is normal that your wireless device gets hot when you use it. Before you clean or maintain the wireless device, stop all applications and disconnect the wireless device from your PC.
Page 14
Specific Absorption Rate (SAR) THIS USB STICK MEETS THE GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES. Your wireless device is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S.
of safety to give additional protection to the public and to account for any variations in measurements. Exposure to RF Energy Use only the supplied or an approved replacement antenna. Do not touch the antenna unnecessarily when the USB Stick is in use. Do not move the antenna close to, or touching any exposed part of the body when making a call.
The USB Stick was tested on all four sides of the unit with the bottom and one side being installed in a laptop. The top and other side was on a USB extension cable. The device can be used in notebook computers with substantially similar physical dimensions, construction, and electrical and RF characteristics.
12 MONTH LIMITED WARRANTY Personal Communications Devices, LLC. (the “Company”) warrants to the original retail purchaser of this device, that should this product or any part thereof during normal consumer usage and conditions, be proven defective in material or workmanship that results in product failure within the first twelve (12) month period from the date of purchase, such defect(s) will be repaired or replaced (with new or rebuilt parts) at the Company’s option, without charge for parts or labor directly related to the defects.
Page 18
When sending your wireless device to Personal Communications Devices for repair or service, please note that any personal data or software stored on the device may be inadvertently erased or altered. Therefore, we strongly recommend you make a back up copy of all data and software contained on your device before submitting it for repair or service.
Page 19
No person or representative is authorized to assume for the Company any liability other than expressed herein in connection with the sale of this product. Some states or provinces do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damage so the above limitation or exclusions may not apply to you.