Cisco Unified Communications Manager Phone
Setup
•
•
•
•
•
•
•
•
•
Set Up Cisco IP Phone
If autoregistration is not enabled and the phone does not exist in the Cisco Unified Communications Manager
database, you must configure the Cisco IP Phone in Cisco Unified Communications Manager manually. Some
tasks in this procedure are optional, depending on your system and user needs.
For more information about Cisco Unified Communications Manager Administration, see the documentation
for your particular Cisco Unified Communications Manager release.
Perform the configuration steps in the following procedure using Cisco Unified Communications Manager
Administration.
Procedure
Step 1
Gather the following information about the phone:
• Phone model
• MAC address
Set Up Cisco IP Phone, page 67
Determine the Phone MAC Address, page 70
Phone Addition Methods, page 70
Add Users to Cisco Unified Communications Manager, page 72
Add a User to an End User Group, page 73
Associate Phones with Users , page 74
Survivable Remote Site Telephony, page 75
Enhanced Survivable Remote Site Telephony, page 77
Application Dial Rules, page 78
Cisco IP Phone 8800 Series Administration Guide for Cisco Unified Communications Manager
5
C H A P T E R
67