Craftsman 315.EL2100 Operator's Manual page 7

SWITCHING MODES:
To switch modes, press the MODE button. The selected
mode will be displayed above the frequency. Press the
MODE button until the desired mode is selected. There
are four modes:
 FM mode
 AM mode
 AUX mode
 BLUETOOTH mode
®
AM/FM TUNING:
Use the SCAN and SCAN
to the desired radio frequency. The selected frequency is
displayed on the LCD.
 Press the SCAN button to tune to a lower frequency
and press the SCAN
frequency.
NOTE: Briefly press either button (not press and hold)
to tune one frequency step at a time. Press and hold
either button to quickly find the next frequency with
clear reception.
 To decrease interference or electrical noise, adjust the
position of the antenna or move the radio to a higher
elevation. The antenna folds down and out of the way
when not in use.
STORING A PRESET IN MEMORY:
The memory feature saves up to 20 frequencies as
presets in the radio's memory. You can save up to ten (10)
frequencies each for FM and AM modes.
 Tune to the desired AM or FM frequency.
 Press and hold the PRESET button until the word
"MEMORY" and the preset position number flash on
the screen.
 Press the SCAN or SCAN
preset position number.
NOTE: There are ten (10) preset positions for FM and
ten (10) for AM. Only one station can be saved in each
preset position.
 Press the PRESET button again to store the frequency.
To tune to presets (FM or AM mode):
 Press and release the PRESET button to cycle through
each preset position number and its associated
frequency.
SETTING THE CLOCK:
The time appears on the LCD display when the radio is
on.
 Press and hold the CLK/DSPY button until the "hour"
display blinks.
OPERATION
buttons to manually tune
button to tune to a higher
button to choose a
 Press the VOL + or VOL - button to select the hour.
NOTE: Time is displayed in 12-hour format only. To
select an hour that is after noon and before midnight,
cycle the hours until "PM" appears in the display.
 Press and release the CLK/DSPY button to lock in the
hour setting. "Minutes" will begin to blink.
 Press the VOL + or VOL - button to select the desired
number.
 Press and release the CLK/DSPY button again to
confirm the time.
USING A PHONE/MP3 PLAYER (NOT
INCLUDED) WITH THE RADIO
See Figure 5, page iii.
 Press the MODE button until AUX mode is highlighted.
 The retainer strap may be used to secure the device
into position.
 Connect integrated auxiliary cable to the device.
NOTE: The auxiliary cable cannot be removed from the
radio.
 The phone/MP3 player must be on and in play mode
for sound to be heard through the speakers.
 All phone/MP3 player controls can be used normally
while connected to radio.
NOTE: Volume for any device connected through the
integrated auxiliary cable can be adjusted using the
volume control for that device or by using the radio's
VOL + or VOL - button.
 Turning the radio off will NOT turn the phone/MP3
player off.
 The integrated auxiliary cable DOES NOT provide
charging function.
 For complete operating instructions for the connected
device, always refer to the manual that was included
with your device.
USING THE USB DEDICATED CHARGING
PORT
See Figure 6, page iii.
The USB dedicated charging port provides charging
power of 5 Volts DC at up to 1 Amp for your cell phone,
MP3 player, or other USB devices.
NOTICE:
Attempting to charge devices rated more
than 1 Amp, such as a tablet, could damage the
USB dedicated charging port and/or the device.
 Connect one end of a USB cable (not provided) to your
USB device.
7 - English