Whirlpool RJE-395P Use And Care Manual page 13

Hold surface unit level
when replacing.
Prop up the top with
support rod.
Replacing reflector bowls and surface units:
Be s&e the surface unit controls are on "OFF."
Put the reflector bowls back into their places. Make sure you can see
the plug-ins (receptacles) for the surface units through the square
hole in the side of each bowl and trim ring.
Hold the surface unit level with the prongs (terminals) pointing at
the plug-In
With the prongs started in the plug-in. start pushing in on the surface
unit. At the same time, lift a little on the side of the surface unit that's
by the plug-in.
Make sure the surface-unit prongs are pushed into the plug-in as far as
they will go The surface unit should fit into the reflector bowl and be
level
Cleaning under the cooktop:
To clean the area under the cooktop. lift the front of the cooktop at
t!w center RalsP the swing-up rod to hold it (Be sure the tip of the rod is
111 the notch 111 the cooktop.) Use warm soapy water and a sponge or cloth.
+c,uring poLL&rs or any other abrasive cleaner may harm porcelain
t'nCrmcl finishes and can scratch chrome
Be careful not to raise the cooktop so high that it touches the
L orltrol console And don't drop it. Dropping the cooktop can chip or crack
il hard pnrcelaln finish or damage side panels and surface units
Removing the storage drawer (use care when handling the drawer):
The clraK)er below your oven is meant to store pots and pans
Never keep anything in there that will burn or melt.
You may want to remove the drawer for cleaning under the range.
Pull It straight out until it stops.
Use care when handling the drawer.
Lift
the front alld pull some more to get it over the stop. Now slide it out until
it stops again Lift the drawer away from the range until it slips out of the
y u I d e s
To put i: back. fit the side rails at the back of the drawer into both
gu~ties 011 thtJ Ianye Push it closed ushile lifting the front to get past the
stc ,ps
Pull to stop. Lift: pull
again.
13