Related Manuals for Comelit IPSWR030A
Summary of Contents for Comelit IPSWR030A
- Page 1 REPEATER SWITCH, 3 POE GIGABIT PORTS ART. IPSWR030A Please read this manual thoroughly before use and keep it for future reference...
-
Page 2: Table Of Contents
Contents 1. Installation ....................3 2. Checklist ..................... 3 3. Installation ....................4 3.1 Installation Method ....................... 4 3.2 Desktop or Shelf Installation ..................4 4. Powering on the Switch ................4 5. Powering on the Switch ................5 6. Network Connection .................. 5 7. -
Page 3: Installation
1. Installation The is 3 ports Gigabit POE (Power over Ethernet) Repeater Ethernet switch, it full compliance with IEEE802.3at standard, with one PD (Power Device) port; two PSE (Power Source Equipment) ports. This switch can work through receiving power from other PoE switch or equipment by PD port, the PSE port can supply power to other PD equipment (the power is less than 30W), it achieve more flexible network applications like this and it don't require external power adapter. -
Page 4: Installation Method
3. Installation 3.1 Installation Method The site where you install the switch may greatly affect its performance. When installing, please take the following consideration. - Install the switch in a cool, dry place. See technical specifications for the acceptable temperature and humidity operating ranges. - Install the switch on a secure, level surface that can support its weight, at least 1Kg. -
Page 5: Network Connection
5. Powering on the Switch Status Description Switch has a connection from PD port to PSE device. Power has been successfully applied. PD (Orange) Connection to PSE device is not present, no power has been applied to the switch. PD device such as IP Phone is connected to the port and drawing power. -
Page 6: Technical Specifications
Typical Installation of the switch - Connect the switch from the PD port to your Gigabit POE Switch. - Connect your IP device at the PSE port on the switch. - Connect your Computer or other IP device to the PSE2 port on the switch. 7. -
Page 7: Appendix: The Standard Rj-45 Introduction
Frame Filtering and Forward 148800pps Rate Operating Temperature: 0℃~40℃ Storage Temperature: -40℃~70℃ Environment Operating Humidity: 10%~90% non-condensing Storage humidity: 5%~90% non-condensing Appendix: The standard RJ-45 Introduction Please note cable-making methods, because cable which does not meet the standards of the sequence data will make the data transmission speed slow, unstable and even be blocked. - Page 8 The standard cable, RJ-45 pin assignment The following shows straight cable and crossover cable standard connection. Please use straight cable to connect switch/hub or other devices: Straight cable for the switch (uplink MDI-II port) to switch/hub or other devices connection Cross over cable for switch (MDI-X port) to switch/hub or other network devices (MDI-X port) connection.
Need help?
Do you have a question about the IPSWR030A and is the answer not in the manual?
Questions and answers