Remap a Key to Run a Command
1. Select the modifier key from the Modifier Mode options.
2. Select the key to be remapped from the Key pull-down list.
3. Select RunCmd 1-4 from the remapped key from the Remapped Key pull-down list.
4. Click on the
RunCmd
(page 5-41) tab.
5. Make sure the CMD radio button is selected.
6. In the text box (RunCmd1-4) corresponding to the number selected for RunCmd1-4, enter the desired com-
mand.
7. If any parameters are needed for the command, click on the PARM radio button. This clears the text box
(though the command is saved). Enter the desired parameters in the appropriate text box.
8. Click OK to save the result and close the control panel.
9. If the KeyMap tab is accessed again, the command plus any specified parameters is displayed in the Key
Sequence text box when the remapped key is again selected.
5 - 39