Walkera WK-0405 Manual
  1. Manuals
  2. Brands
  3. Walkera Manuals
  4. Transmitter
  5. WK-0405
  6. Manual

Walkera WK-0405 Manual

For rc helicopters
Hide thumbs
Table of Contents

Advertisement

Quick Links

RX-408

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WK-0405 and is the answer not in the manual?

Questions and answers

Related Manuals for Walkera WK-0405

Summary of Contents for Walkera WK-0405

  • Page 1 RX-408...

  • Page 2: Table Of Contents

    Contents Introduction Warning Cautions Transmitter Features Receiver Identification Switch Between Left-Hand and Right-Hand Throttles Flybar Set Assembly Battery Mounting and Adjustment Swashplate Adjustment Main Rotor Blade Adjustment Flight Mode...

  • Page 3: Introduction

    Warning 1. Walkera helicopters are not toys. They are a complex combination of electronics and mechanics which produce an aerodynamic rotorcraft. All models require proper setup and exacting adjustments to avoid accidents. We accept no liability for damage and/or consequent damage arising from the use or misuse of the products due to improper construction methods, use or operation, It is your responsibility to operate this highly advanced model in a safe manner.

  • Page 4: Cautions

    Cautions 1. Because the helicopter is operated by radio control, it is important to make sure you are always using fresh and/or fully charged batteries. Never allow the batteries to run low or you could lose control of the helicopter. 2.

  • Page 7: Receiver Identification

    Remove the battery pack, RF module and the 4 fixing screws in the back cover of your WK-0405, and take off the back cover (Note: don't break cables inside). Unscrew the fixing screw of linkage using cross screwdriver and fix the linkage of another side Throttle DIP Switch (switching using the screw.

  • Page 8: Flybar Set Assembly

    Flybar Set Assembly Flybar block sleeve Flybar block Flybar 1. Let the location notch of flybar block aim at the flybar, and press the flybar block till the flybar reaches the end of notch; Insert one end of the flybar through hole 1 (Fig.

  • Page 9: Swashplate Adjustment

    Fig. 7 2. CG balance. Put your helicopter on a horizontal ground and make the flybar perpendicular to the tail truss of your helicopter. Lift your helicopter using your index fingers to support the two sides of flybar, and check the balance.

  • Page 10: Main Rotor Blade Adjustment

    Main Rotor Blade Adjustment Fig. 10 1. Main rotor blade inspection. (1) Inspect whether the fixing screw of the main Short ball linkage rotor blades are too tight or loose. Extreme tightness or loosing of the blades will result in instable flight. (2) Inspect the blade tracking problem. Blade tracking Fixing screw will lead to instable flight.

  • Page 11: Flight Mode

    Flight Mode Normal Mode throttle elevator stick ascending pushing head forward pushing up throttle descending head elevator stick pulling backward pulling down down head turning rudder stick aileron stick helicopter left moving left moving left moving left head turning rudder stick helicopter aileron stick right...

Table of Contents