Cruise Control - Seat Ibiza Owner's Manual

Resetting service interval display
If the service was not carried out by a SEAT
dealership, the display can be reset as fol-
lows:
● Switch off the ignition, press and hold but-
›››

ton Fig. 105 .
4
● Switch ignition back on.
›››

Release the
●
4
press it again for the next 20 seconds.
Note
The service message disappears after a few
●
seconds, when the engine is started or when
is pressed on the windscreen wiper
OK/RESET
lever, or on the multifunction steering
OK
wheel.
● In vehicles with the LongLife system in
which the battery has been disconnected for
a long period of time, it is not possible to cal-
culate the date of the next service. Therefore
the service interval display may not be cor-
rect. In this case, bear in mind the maximum
service intervals permitted in the
let Maintenance Programme.
32

Cruise control

Operating the cruise control system
(CCS)*
Fig. 105 button and
Fig. 38
lever: switches and controls for operating the
CCS
● Switching on the CCS: Move switch
›››
Fig. 38
speed has been programmed, the system will
not control it.
›››
Book-
● Activating the CCS: Press button
in the  area. The current speed is
2
memorised and controlled.
The essentials
Turn signal and main beam headlight
to . The system is on. If no
1
›››
Fig. 38
● Temporarily switching off the CCS: Move
›››
switch Fig. 38 to  or push the
1
brake. The cruise control system is switched
off temporarily.
● Reactivating the CCS: Press button
›››
Fig. 38
in . The memorised speed
2
is saved and controlled again.
● Increasing stored speed during CCS regula-
tion: press button in . The vehicle ac-
2
celerates until the new stored speed.
Reducing stored speed during CCS regula-
●
tion: press button in  to lower the
2
speed by 1 km/h (1 mph). Speed is reduced
until reaching the new stored speed.
Switching off the CCS: Move switch
●
›››
Fig. 38 to . The system is disconnec-
1
ted and the memorised speed is deleted.

›››
in Operation on page 160

›››
page 159