Directions - Pelican PREDATOR 24 PL-6614 Manual

Directions

1. Make sure your PlayStation®2 is turned off.
2. Remove the battery lid and place 2 AA batteries into the
Predator 2.4 Wireless controller. Make sure the batteries
are inserted as shown in the battery compartment. A pair
of matched,fresh, premium, batteries will yield best results.
3.
Insert the receiver into the
PlayStation®2 controller slot 1 (or slot 2 if
slot 1 is already occupied) and power up
the Predator 2.4 and then your
PlayStation®2. Note: Locate the Connect
Button at the bottom of the receiver.
Insert a pin into the hole and push the
Connect Button inward once on the
receiver (Signal LED will FLASH Slowly).
Then press the Select Button on con-
troller. This programs the Receiver to con-
nect to that Controller every time it is
used. This operation can be done again and again to con-
nect to multiple Controllers.
4. Alternatively, if any problems should occur during play
(due to low batteries, receiver disconnection from the sys-
tem,etc.) you can turn the controller off and then on, check
the control, and if you still do not have signal, press the
connect button on the receiver, wait three seconds and
then press the Start button or one of the action Buttons.
Note: If you are using more than one Predator 2.4
Wireless Controller, simply repeat the above steps and it
should connect exactly the same way on an available
channel.
5. Insert a game into your PlayStation®2.
6. You are now ready to play.
9