Gardman 19058 Manual

Coral springs outdoor water feature

Advertisement

19058 Coral Springs Outdoor Water Feature
Please read the assembly instructions and separate pump instructions carefully prior to installation.

Assembly Instructions

Unpack all the water feature components from the packaging and lie on a flat surface.
Remove the top part (1) of the feature and connect the rubber tube (3) that is located on the
underside in to the opening on the pump (2). Lay the pump inside on the base of the feature (4).
Make sure the tube is properly connected and is not kinked.
The pump flow can be adjusted by moving the dial (5) which is located on the inlet of the pump.
Connect the two cables (6) & (7) and screw over the plastic collar (8) until secure.
Position the cable through the cable slot located on the top part of the water feature under the head
piece. Plug the 2 pin connector (9) in to the plug/transformer (10). Do not insert the plug in to the
mains at this time.
Fill the reservoir in the base with water up to halfway from the top.
www.gardman.co.uk

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 19058 and is the answer not in the manual?

Questions and answers

Summary of Contents for Gardman 19058

  • Page 1 19058 Coral Springs Outdoor Water Feature Please read the assembly instructions and separate pump instructions carefully prior to installation. Assembly Instructions • Unpack all the water feature components from the packaging and lie on a flat surface. • Remove the top part (1) of the feature and connect the rubber tube (3) that is located on the underside in to the opening on the pump (2).
  • Page 2 • Regularly top up the water inside the feature. • To keep your feature free of algae and mould we recommend you use Gardman’s Crystal Clear sachets that are available from your Gardman water feature stockist. • Throughout the winter months you should drain and clear your feature of water so ice does not form.
  • Page 3 19058 Coral Springs Outdoor Water Feature 3) If water is splashing outside the fountain or the pump is running with slow water circulation check the following; a) Adjust the flow control switch located on the inlet of the pump accordingly for a more suitable flow rate and always make sure the pump is completely submersed in water.
  • Page 4 Retailer Address: Customer Information Thank you for your purchase of this Gardman water feature. The water feature is guaranteed for one year. If you have any problems or queries with this water feature then please contact our helpline number: 01406 372227 or write to: Gardman Ltd, High Street, Moulton, Spalding, Lincs, PE12 6QD.

Table of Contents