Related Manuals for Microlab T-9752 U
Summary of Contents for Microlab T-9752 U
-
Page 1: Instruction Manual
T-9752 U 16-Channel UHF FM Transceiver400-470MHz T-9752 V 16-Channel VHF FM Transceiver130-174MHz Instruction Manual... - Page 2 SAFETY INFORMATION Your wireless handheld por t able transceiver contains a low power transmitter. When the Push-To-Talk (PTT) button is pressed, it sends out radio frequency signals. The device is authorized to operate at a duty factor not to exceed fifty percent. CAUTION To maintain compliance with the FCC s RF exposure guidelines, hold the transmitter and antenna at least two inches from your face and speak in a normal voice, with the antenna pointed up and away from your face.
-
Page 3: Thank You
THANK YOU We are grateful for your purchase of this microlab transceiver .We believe this easy-to-use transceiver will provide you with dependable and reliable communications. Microlab We adopt advanced technology & workmanship for this transceiver,we trust our aborative design will make it better &quicker service for you ;for correct usr ,please read this manusl before use. -
Page 6: Table Of Contents
CONTENTS UNPACKING AND CHECKING EQUIPMENT Supplied Accessories PREPARATION Charging the Ni-MH Battery pack Installing/Removing the Battery Pack Installing the Antenna Installing the Belt Clip Installing the Cover over the speaker/Microphone jacks Installing the Optional Speaker/Microphone GETTING ACQUAINTED T-9752 T-9752 OPERATION AUXILIARY FUNCTIONS Time-out Timer Battery Save... -
Page 7: Unpacking And Checking Equipment
Spesker/ Antenna Instruction Belt clip Ltem Screw (T-9752 only)7.2V(1600mAh) T-9752/T-9751 microphone jack cover T-9752 U/V Manual Quantity Note :A market code(M,M2,orM4)can be found on the label attached to the package box. Antenna Battery charger Ni-MH battery Spesker/ T-9752 U/V pack... -
Page 8: Preparation
PREPARATION Charging the Ni-MH Battery pack The battery pack is not charged at the factory;charge it before use . Initially charging the battery pack after purchase or extended storage (greater than 2 months ) will not bring the battery pack to its normal operating capacity. - Page 9 Plug the AC adaptor into an AC outlet. Slide the Ni-MH battery pack or transceiver with a Ni-MH battery pack into the charger. lMake sure the battery pack contacts are in contact with the charging terminals. lThe charger LED lights and charging begins. After charging the supplied battery pack for 8 hours ,remove it or the transceiver equipped with it from the charger.
-
Page 10: Installing/Removing The Battery Pack
Installing/Removing the Battery pack The average life of the supplied Ni-MH battery pack is 8 hours .Average times are calculated using 5% transmit time 5% receive time ,and 90%standby time . CAUTION DO NOT SHORT THE BATTERY TERMINALS OR DISPOSE OF THE BATTERY BY FIRE. NEVER ATTEMPT TO REMOVE THE CASING FROM THE BATTERY PACK . -
Page 11: Installing The Antenna
Installing the Antenna Installing the Belt Clip Screw the antenna into the connectoron the top of the transceiver by holding the antenna ta its base and turning it clockwise until secure. Ntoe The antenna is neither a handle, a key ring Insert the belt clip to the battery slot retainer,nor a speaker/microphoneattachment point. -
Page 12: Getting Acquainted T-9752
GETTING ACQUAINTED T-9752 Antenna Channel(selector) PTT push-TO Talk switch Rotate to select Press,then speak into LED indicator channels 1~16 the microphone to call a station.Release Lights red while to receive. transmitting.Linghts green while receiving a signal. Flashes red Power switch Speaker/ when the battery /volume control... -
Page 13: T-9752 Operation
T-9752 OPERATION Adjust the volume by To make a call ,press and Switch ON the transceiver Rotate the Channel by turning the Power pressign and holding the selector to select your hold the PTT switch ,the switch / Volume control Monitor key ,then rotating desirde channel. -
Page 14: Auxiliary Functions
AUXILIARY FUNCTIONS Time-out Timer The purpose of the Time-out Timer is to prevent any single person from using a channel for an extended period of time . If you continuously transmit for 10 minutes, the transceiver will stop transmitting and a tone will sound. To stop the tone,release the PTT switch.You can press the PTT switch again to resume transmittign Battrey save The Battery Save function decreases the amount of power used when a signal is not being received and no operations are being... -
Page 15: Optional Accessories
OPTIONAL ACCESSORIES You can use the following accessories with your transceiver T-52BS Standard Battery 7.2V/1100mAh T-52B Long Life Battery 7.2V/1600mAh T-512B Regular Battery Charger T-EP Head set with VOX Voice Operated Transmit T-SM Remote speaker T-51BC Belt clip TROUBLESHOOTING GUIDE Other voices (besides group Battery power dies Cannot talk to or hear other members... -
Page 16: Frequency Chart
FREQUENCY CHART Model Name T- Transmit Frequency Frequency Receive QT/DQT Channel Serial Number... - Page 17 www.microlab.com.cn...
Need help?
Do you have a question about the T-9752 U and is the answer not in the manual?
Questions and answers