Safety Instructions For Battery-Powered Tools; Package Contents; Description; Electrical Safety - DeWalt DC010 Manual

Warning! The use of any accessory or attachment
or performance of any operation with this tool
other than those recommended in this instruction
manual may present a risk of personal injury.
6 Check for damaged parts
Before using the tool, carefully check it for damage
to ensure that it will operate properly and perform
its intended function. Check for misalignment
and seizure of moving parts, breakage of parts
and any other conditions that may affect its
operation. Have damaged guards or other
defective parts repaired or replaced as instructed.
Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
D WALT repair agent.
E
7 Store idle tools
When not in use, tools must be stored in a dry
place and locked up securely, out of reach of
children.
8 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Keep all handles and switches dry,
clean and free from oil and grease.
9 Repairs
This tool is in accordance with the relevant safety
regulations. Have your tool repaired by an
authorised D WALT repair agent. Repairs should
E
only be carried out by qualified persons using
original spare parts; otherwise this may result in
considerable danger to the user.
Safety instructions for mains-powered tools
10 Extension cables
Before use, inspect the extension cable and
replace if damaged. When using the tool
outdoors, only use extension cables intended for
outdoor use and marked accordingly.
11 Unplug tool
Switch off and wait for the tool to come to a
complete standstill before leaving it unattended.
Unplug the tool when not in use, before changing
any parts of the tools, accessories or attachments
and before servicing.
12 Do not abuse cord
Never carry the tool by its cord. Never pull the
cord to disconnect from the socket.
Keep the cord away from heat, oil and sharp
edges.

Safety instructions for battery-powered tools

13 Remove the battery pack
Switch off and wait for the tool to come to a
complete standstill before leaving it unattended.
Remove the battery pack when not in use, before
changing any parts of the tools, accessories or
attachments and before servicing.

Package contents

The package contains:
1 Radio
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your DC010 radio has been designed for playing
radio transmissions at construction sites.
Working on mains (corded) or battery (cordless) power
the tool can be used both indoor and outdoor.
For cordless applications, the tool accepts D
NiCd and NiMH battery packs ranging from 7.2 to 18 V.
1 Volume control
2 Mode selector
3 Station selector
4 Latch
5 Scale

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 60065; therefore no
earth wire is required.
E N G L I S H
WALT
E
15