JVC XV-S40BK Service Manual page 21

Removing the traverse mechanism
assembly (See Fig.4 and 5)
Prior to performing the following procedure, remove
the clamper assembly and the tray.
1. Remove the four screws B attaching the traverse
mechanism assembly.
ATTENTION: Before reattaching the traverse
mechanism assembly, pass the card
wire extending from the spindle motor
board through the notch d of the
elevator.
Removing the elevator (See Fig.6 and 7)
Prior to performing the following procedure, remove
the clamper assembly, the tray and the traverse
mechanism assembly.
1. Extend each bar e inside of the loading base
outward and detach the elevator shaft.
ATTENTION: When reattaching, first fit the two
shafts on the front of the elevator to
the slots f of the slide cam.
Shafts
Elevator
Fig.7
Traverse mechanism
assembly
Elevator
Slide cam
Slots f
XV-S40BK/XV-S42SL/XV-E100SL
B
B
Fig.4
B
Traverse mechanism assembly
Fig.5
e
Loading base
Fig.6
B B
B B
B B
Elevator
Notch d
Elevator
Elevator
e
1-9