Table of Contents
Advertisement
HULL
HOOD
Deck and hull
1
b
a
a
1
Drain plug check
2
1. Check:
Front protector 1 installation
1. Install:
NOTE:
Apply soapy water to the inner surfaces a of
the grommets before installing the projections
b of the front protectors.
Pull-up cleat cover installation (FX
Cruiser SHO)
1. Install:
NOTE:
Make sure that the word "YAMAHA" a on
each pull-up cleat cover can be read correctly
from the side of the watercraft as shown.
Reboarding step installation
1
1. Install:
Installation steps:
1. Fasten the brackets in both sides of the
2. Finger tighten all of the bolts, and then
8-54
• Drain plug 1
• O-ring 2
Cracks/damage → Replace the drain
plug.
• Front protectors
• Pull-up cleat covers
• Reboarding step
reboarding step in the down position with
plastic ties 1 as shown so that they will
not return to the up position.
tighten them to the specified torque.
Reboarding step assembly bolt:
16 N·m (1.6 kgf·m, 11.8 ft·lb)
LOCTITE 271
E
1
2
3
4
5
6
7
8
9
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the WaveRunner FX SHO and is the answer not in the manual?
Questions and answers
How do I remove the drive coupling from the rear of my engine. I **** transfering it to another engine
To remove the drive coupling from the rear of a Yamaha WaveRunner FX SHO engine, follow these steps:
1. Remove the generator cover.
2. Hold the flywheel magneto using the special service tools:
- Shaft holder: 90890-06721
- Driver handle: 90890-06722
3. Remove the drive gear assembly bolt by turning it clockwise (it has left-hand threads).
4. Use the special service tools to remove the drive gear assembly:
- Bearing puller assembly: 90890-06535
- Stopper guide plate: 90890-06501
- Stopper guide stand: 90890-06538
These steps ensure the correct removal procedure while avoiding damage to the components.
This answer is automatically generated