Table of Contents
Advertisement
USING THE BLOWER
Always be aware of the strength and direction of the air stream.
•
•
Never direct the blower towards people or animals.
SELECTING THE OPERATING MODE
Set adjustment lever (8) to vacuum
•
When using as a leaf vacuum: Insert the collection bag (9) as shown into the device and ensure that it clicks into place.
•
SETTING THE BLOWER OR VACUUM SPEED
•
Set the speed regulator (6) to the required blowing or vacuuming speed.
SWITCHING ON AND OFF
•
Set the On/Off switch to position [1] to switch the appliance on.
•
Set the On/Off switch to position [0] to switch the appliance off.
MAINTENANCE & CLEANING
WARNING
Improper maintenance & storage of the machine may void your warranty.
Keep the machine clean for better and safer performance.
DANGER
Risk of injury! Switch off the product and disconnect the mains plug before all cleaning and maintenance work. Wait till
all moving parts are completely stopped.
MAINTENANCE
•
Before each use, check all nuts & bolts to be sure they are sufficiently tightened.
We recommend only manufacturer original parts are used when maintaining this machine. Failure to do so could
•
invalidate your manufacturer's warranty.
•
The engine must be switched off, with the spark plug cap removed, before the machine is unassembled, cleaned,
serviced or maintained.
CLEANING
Keep your machine clean.
Thoroughly clean the machine at the end of each use, paying particular attention to cuttings in and around the guard and
cutting tool.
Brush off coarse dirt.
•
•
Wipe down the device with a slightly damp cloth.
Clean the catch-sack regularly
•
SUCTION & BLOWER TUBES
•
It is advisable to remove the Suction & Blower tubes from the machine regularly for cleaning.
•
Use soapy water to remove any dirt or grime.
MOVING THE COLLECTION BAG
Push the unlocking button (11) and fold the handle (10) downwards.
•
•
Shake out the collection bag thoroughly, turn inside out and brush the bag out.
You may wash the bag with a very mild detergent BY HAND, but ensure it is completely dry before attaching to the
•
machine and use.
•
Regularly check the bag for rips, tears or holes and replace immediately if damaged.
RECTIFY CLOGGING
•
Release the locking screw (13).
Fold up the housing cover (14) and remove any blockage.
•
WEEBV260 IM.indd 11
or blow
.
17/01/2017 11:22
Advertisement
Table of Contents
