Cutting Line; Feeding More Line; Replacing The Cutting Line; Remove The Spool - Tesco CDGT0216 User Manual

Tesco CDGT0216

CUTTING LINE

Feeding more line

• The trimming head is equipped with a bumper
to release and cut the trimming line. To release
more line, tap the bumper on a firm surface while
running and the spool will release fresh trimming
line.
A new length of line will feed out automatically.
• Let the Grass Trimmer run for a few seconds
without touching the working area to allow the
blade fixed in the guard to cut the line after it
lengthens.

Replacing the cutting line

Remove the spool

• Firmly squeeze the two spool cover release
buttons in.
This releases the spool cover.
• Remove the cover.
• Lift out the spool.
• Remove any remaining nylon cutting line from
the spool.
Original Instructions

Fit the new line

• Cut a replacement nylon line of approximate
length 10 m.
• Fold the replacement
cutting line in half and
hook it into the slot in
the centre divider of
the spool.
• Wind the cutting line
onto the two sections
of the spool.
Wind the line onto both
spools in the direction
of the arrow on the
bottom of the spool.
NOTE: One line end can
be hooked into the slots
or holes in the edges of
the spool to prevent it
from unravelling while
you wind the other.
• Continue until all
the line is wound
smoothly onto the
spool.
• Unhook the line from the slots in the spool ends
and thread the ends of the cutting line through
the guide holes in the spool holder with about
120mm visible length.
• Press the spool down and replace the spool cover,
pressing it into position until the release buttons
click into place.
7
3
11