Honeywell SiXCT Installation Instructions

TM
SiX
Series
The SiXCT is a wireless door / window sensor
intended for use with Honeywell controls that
support SiX™ series devices.

Open the SiXCT

• Firmly slide the top and bottom housings in
opposite directions and pull them apart to open
the device.

Mounting

The SiXCT can be mounted with several options:
• Installation with magnet: Make gap is 0.75";
Break gap is 1.30".
• Optional Wiring for Service loops:
a) surface wiring
b) concealed wiring
NOTE: Wiring limit is 3ft.
NOTE: After enrolling and before mounting the
device permanently, conduct Go/No Go tests (see
controller's instructions) to verify adequate signal
strength. Adjust the device location and orientation
as necessary.
SiXCT
Installation Instructions