Table of Contents
Advertisement
Quick Links
Operating Temperature: 32 to 104 degrees F (0C to 40 degrees C)
Storage Temperature: -4 to 158 degrees F (-20 to 70 degrees C
Contact for software questions:
info@aerohive.com
Phone: 408-510-6100
Needed Equipment:
Ethernet hub.
Laptops
AP login information:
Serial connection: 9800, 8, N, 1, no flow control
Login: admin
Password: aerohive
Must have the Ethernet port connected so the EUT gets active link.
Must enter line commands to set channel, power and mode.
Wifi1 – 5GHz radio
Wifi0 – 2.4GHz radio
In the instructions below, enter the correct wifi1 or wifi0 for the appropriate band you are
testing.
To display available channels:
show interface <wifi0 | wifi1> channel
To set channel:
interface <wifi0 | wifi1 > radio channel XX
To set power:
Operating Instructions Manual
Model Name: BR200-WP
Model No., BR200-WP
AC/DC power Adapter Rating: 48Vdc, 1.25A
Relative Humidity: Maximum 95%
<- 2.4GHz or 5G to channel XX
Advertisement
Table of Contents
Related Manuals for Aerohive BR200-WP
Summary of Contents for Aerohive BR200-WP
- Page 1 Operating Instructions Manual Model Name: BR200-WP Model No., BR200-WP AC/DC power Adapter Rating: 48Vdc, 1.25A Operating Temperature: 32 to 104 degrees F (0C to 40 degrees C) Storage Temperature: -4 to 158 degrees F (-20 to 70 degrees C Relative Humidity: Maximum 95% Contact for software questions: info@aerohive.com...
- Page 2 interface <wifi0 | wifi1> radio power XX <-- sets 2.4GHz/5G radio to power XX, note if power XX is greater than the systems internal power limit for japan, it will set power to the limit To change between 20MHz and 40MHz operation, need to load/change the operation radio profiles: radio profile 11na channel-width 40-above <-- will set the 5GHz radio to 40MHz operation, with the extra 20MHz emission located above the current channel.
- Page 3 To start continuous transmission: _test interface wifi tx-chain-mask YY cont-tx XX payload-size 1500 Must use _ before test Must set channel, power and bandwith first YY = 0x1 for single chain, or 0x3 for both chains (use this!) XX = data rate in 500kB/s. (For legacy modes – take the normal data rate and double it, for example, 802.11b 1Mbs/s –...
- Page 4 DFS Instructions Need: DFS client laptop Laptop (192.168.1.2) – VLC Serial server ethernet ethernet ENET Switch DFS client (192.168.1.3) Setup the DFS client to fixed IP address: 192.168.1.3 Set the channel and bandwidth using the radio commands shown previously Once the client laptop associates with the AP, confirm that you can ping the laptop wired to the AP.
Need help?
Do you have a question about the BR200-WP and is the answer not in the manual?
Questions and answers