Advertisement
Instructions and Parts List
3M-Matic
P/N 70-0708-6798-4
S867/S857 U-Clip
Modification Kit
For use on 3M-Matic™
S867 L-Clip Applicator, Type 10500
S857 L-Clip Applicator, Type 29500
Purpose of Kit
The U-Clip Modification Kit is designed to buff a
standard L-clip down to form a U-shaped tape clip
around the edge of thinner cartons when used on the
S867 or S857 L-Clip Applicators. U-clips can be
applied to cartons from 1/4 inch [6.4 mm] thick to 2
inches [50 mm] thick. Refer to the Specifications
section.
Contents of Kit
Quantity
Description
1
Buffing Assembly
1
Buffing Sleeve
2
Capscrew, Soc. Hd., 10-24 x 1/2 Lg
2
Washer, Plain, Type A, #10
1
Instructions and Parts List
TM
Specifications
Tape length applied, total: 4 1/2 inches [115 mm]
U-clip tape lengths:
Bottom of carton:
End of carton:
Top of carton:
Carton size capacity:
1/4 inch [6.4 mm] minimum
2 inch [50 mm] maximum
2 1/4 ± 1/8 inch
[55 mm ± 3.2 mm]
Thickness of carton
2 1/4 [55 mm], minus
thickness of carton
Advertisement
Table of Contents
Summary of Contents for 3M-Matic S867 L-Clip Applicator
-
Page 1: Specifications
3M-Matic P/N 70-0708-6798-4 S867/S857 U-Clip Modification Kit For use on 3M-Matic™ S867 L-Clip Applicator, Type 10500 S857 L-Clip Applicator, Type 29500 Purpose of Kit Specifications Tape length applied, total: 4 1/2 inches [115 mm] The U-Clip Modification Kit is designed to buff a... -
Page 2: Installation
Installation WARNING • To reduce the risk associated with mechanical hazards: − Turn air supply off and disconnect before performing any adjustments, maintenance, or servicing the machine or taping heads. • To reduce the risk associated with sharp blade hazards: −... -
Page 3: Operation
Installation (Continued) 6. Cut air line number 17 on the flow control valve approximately 1 inch [25 mm] down from the L- fitting as shown in Figure 4. Note that the position of air line 17 on the S867 is different than its position on the S857. -
Page 4: Replacement Parts List
(5) business days after the expiration of the warranty period. All notices required hereunder shall be given to 3M solely through the 3M-Matic™ Helpline (800-328-1390). To be entitled to repair or replacement as provided under this warranty, the part must be returned as directed by 3M to its factory or other authorized service station designated by 3M. - Page 5 Hole Location Template Center punch four (4) holes indicated by Remove template and drill four (4) 0.1495 (#25 drill) holes. Tap four (4) holes with 10-24 tap. Cut out and remove this circle for clearance around on/off valve. Line up these two edges of template with front and left side of S867 applicator and secure template to applicator with masking tape.
- Page 6 Hole Location Template (See other side)
Need help?
Do you have a question about the S867 L-Clip Applicator and is the answer not in the manual?
Questions and answers