Setting The Clock - Sharp CD-JX20X(GY) Service Manual

n
n
Remote Control Transmitter Window
2. operate Button
3. Presetl Buttons
4. Tuner Call Button
5. Band Selector Button
l CD control buttons
6. Programme Button
7. Call Button
8. Clear Button
9. CD Call Button
10. Cue Button: *
11. Review Button: *
12. Pause Button: II
13. Taoe Lenath Selector Button
14. Track Number Input Buttons
15. Stop Button: n
16. Play/Repeat Button: b 5
17. Track Up/Down Buttons: H1 I H
19. Auto Editing Button
l
Tape control buttons
20. Tape Call and Tape I/2 Select Button
once. After the functvx- has chanoed to TAPE. TAPE 1 or 2 can
then be selected by pressing the-button agam.
21. Reverse Play Button: 4
22. Record Pause Button: l II
23. Forward Play Button: b
24. Stop Button: n
25. Fast Wind/APSS Buttons: e I w
26. Volume Up/Down Buttons: v I A
27. Auxiliary Call Button
Aim (wIthIn the ranoe of 30" with no obstacles1 the remote control at
the remofe control &nsar and operate as sh&n
Notes concerning use:
l Replace the batteries If control distance decreases or oper-
l Exposmg the sensor on the ma," un,t to strong light can
the " " ,I
l Keep the remote conlrol away from moisture, excessive
heat, shock, and vrbralions.
l The remote controlls usable range IS between 0 2 m (0.7
feet) and 6 m (20 feet) away from the sensor
l Whilst the frequency Indicator on the tuner or the " ON TIME" in-
dicator IS 11t. press the DISPLAY button to display the hme
l Press the HOUR button once lo advance the time by 1 hour Press
for more than 2 seconds to advance continuously.
" AM" changes automatically to " PM" .
l On the display, midnight
?. " AM 12:Oo" and noon is " PM 12.00~.
I
When settmg the hme, be careful not 10 confuse AM and PM.
Whilst pressmg the TIME ADJ button, press the MINUTE
button and set the time to 1 minute before the desired time.
. Press the MINUTE button once to advance the hme by 1 rmnute.
Press for more than 2 seconds to advance con11nuousIy.
" 59" to " 00" .
button once to start the clock at the correct time.
Note:
l When setting the time, complete the procedure withln 1 minute; 11
more than 1 minute elapses, the " minute" mdrcation will advance.
l When the current time and timer clock are not displayed, remove
the AC power lead, remove the clock/memory batteries, then re-