Connection And Installation; Connections; Connect The Receiver To Your Tv And Vcr - Philips 0 User Manual

3 Connection and Installation

3.1 Connections

3.1.1 Connect the receiver to your TV and VCR

Incorporate the receiver in your existing installation as shown below / decoder receiver.
1
Plug your aerial lead plug into the "AERIAL IN" socket of your digital receiver.
2
Connect the "RF OUT" socket of your digital receiver to the "Aerial input" socket of your VCR by
means of the RF coaxial lead supplied with your digital receiver.
3
Connect the "RF OUT" socket of your VCR to the "Aerial input" socket of your TV set by means
of a RF coaxial lead.
4
Connect the "TV" SCART socket of your digital receiver to the RGB capable SCART socket of
your TV set by means of the SCART lead supplied with your digital receiver.
5
Connect the "VCR" SCART socket of your digital receiver to the "EXT1" SCART socket of your
VCR (so called OUT) by means of a SCART lead.
6
Plug all your equipment, excluding your digital receiver, into the mains.
7
Go to chapter 3.2 to proceed with the channel scan of your digital receiver.
Notes:
1- This connection also applies if your VCR has one SCART socket.
2- With this connection set up you can:
- Watch digital TV while you record analogue TV.
- Watch analogue TV while you record digital TV.
- Record the digital TV channel you are watching.
- Watch Play Back from your VCR.
12 C O N N E C T I O N A N D I N S TA L L AT I O N
TV set
Terrestrial
receiver
Video recorder