Sharp DV-NC150U Service Manual page 35

FLOW CHART NO.10
Video E-E does not appear.
Is the Video signal inputted to Pins(28,30,32) of
IC301?
Is the C-SYNC signal outputted to Pin(25) of IC301?
Is the C-SYNC signal inputted to Pin(41) of IC501?
Check the line between Pin(25)
of IC301 and Pin(41) of IC501,
and service it if defective.
Yes
Is the video signal inputted into Pin(1) of IC751?
Is the video signal outputted to Pin(15) of IC751?
Is approximately 5V voltage supplied to Pin(16)
of IC751, or approximately -6V voltage supplied to
Pin(7) of IC751?
Is the "H" pulse inputted into Pins(9,10,11) of IC751?
Replace IC751.
Yes
Yes
No
Replace IC301.
Yes
No
Yes
Yes
No
1) In the external input mode
Check the line between the video input
terminal (rear) and Pin(28) of IC301, and
service it if defective.
Check the line between the video input
terminal (front) and Pin(30) of IC301, and
service it if defective.
2) In the U/V tuner mode
Check the line between Pin(18) of the U/V tuner
and Pin(32) of IC301, and service it if defective.
Is 5V voltage supplied to Pin(23) of IC301?
Check the P-ON+5V line and service it
if defective.
Yes
Is the serial data, clock and chip select signal
supplied to Pins(53, 54, 55) of IC301?
Yes
Check the line between Pins(53,54,55) of IC301
and Pins(14,15,16) of IC501, and service it if
defective.
No
Check the line between Pin(26) of IC301 and
Pin(1) of IC751, and service it if defective.
Yes
Is the video signal outputted to the emitter of Q391?
Check the line between Pin(15) of IC751
and Q391, and service it if defective.
Yes
When only Line signal is not outputted...
check the line between the emitter of Q391 and the
video output terminal (JK751), and service it if
defective.
When only RF signal is not outputted...
check the tuner (TU701), and the line between the
emitter of Q391 and Pin(6) of the tuner, and
service it if defective.
No
Check the AL+5V line and the
AL-30V line (R777,R778), and service it if defective.
No
Replace IC501.
1-10-12
No
No
No
No
H9641TS