Table of Contents
Advertisement
• Primary (IP address)
To set the Primary DNS Server static IP address, tap
Primary and the Enter Address popup appears.
ENTER ADDRESS (popup)
Current
IP address
Keypad
To set a new DNS Server IP address, tap CLEAR,
set the new address by tapping the numbers on the
Keypad, and then tap Accept.
Note: Entering the DNS Server IP address from the
ENTER ADDRESS popup uses the "dotted
decimal" format and must include the "dot(s)" as
part of the entry.
• Secondary (IP address)
To set the Secondary DNS Server static IP address,
tap Secondary and the Enter Address popup
appears. To set a new DNS Server IP address, tap
CLEAR, set the new address by tapping the
numbers on the Keypad, and then tap Accept.
Automatic (IP address)
If a Dynamic Host Configuration Protocol (DHCP)
server is available you can select the Automatic DNS
ADDRESS ASSIGNMENT option and DNS Server
addresses are included in information obtained from
the DHCP server.
To set the Automatic IP address option, tap
AUTOMATIC in the IP ADDRESS ASSIGNMENT
group. The appropriate value for the Primary DNS IP
address and Secondary DNS Server IP address are
obtained from the DHCP server.
CLEAR
"dot"
Accept
Status
Device related Status Messages appear at the top of the
Projectionist Terminal Screen in the area normally
occupied by the Current User information and the Date &
Time. This Status Message area is common to all screens
and the messages appear when the Status Indicator Lamp
is flashing red or yellow. Tap the Close button to remove
the Status Message from the Projectionist Terminal.
Status Messages
Status Message
SMS Computer is Off-line
Encl. Temp exceeded ErrLevel
PDU is Off-line
Media Block Error
RAID is not ready
UPS: Abnormal Condition
UPS: Replace Battery
System Status Warning indicators/buttons appear along
the bottom of the Projectionist Terminal basic screen.
Tap for Menu
Status Messages
Status
Lamps &
Selector
Buttons
Tap for
Tap for
Power Status
Fan Status
Tap for
Lamp Status
The Status indicators are common to all screens and when
tapped directly access the various system status panes.
Under normal conditions their appearance is as sown in the
illustration.
When you tap an indicator to access the
associated Status pane its appearance
changes as shown to the right.
When the associated sub-system is in alarm
the appearance of the indicator changes as
shown to the right.
Status Lamp
Red/Flash
Red/Flash
Red/Flash
Red/Flash
Red/Flash
Yellow/Flash
Yellow/Flash
Close
Tap for
Message
Tap for
Temperature Status
Status
43
Advertisement
Table of Contents
