Figure 2: Status Led On Wla532 Access Point; Table 2: Status Leds On Wla532 Access Points - Juniper WLA532 Hardware Documentation

WLA 532 Access Point Hardware Documentation

Table 2: Status LEDs on WLA532 Access Points

Label Color
LED in Unlit
the
center
Amber, flashing
Green, flashing
Green or amber, flashing
Green
Red
8

Figure 2: Status LED on WLA532 Access Point

Table 2 on page 8 describes the status LEDs and their states.
Status and Description
Off. The access point is powered off.
On. The access point is on power on sand is in self-test mode.
On. The access point is waiting to receive boot instructions and a configuration file
from a wireless LAN controller.
Cindy, the products are named as WLC2, WLC8 etc. So, is it okay to just say WLC?
Or should we use wireless LAN controller always?)
On. The access point is booting and receiving a configuration file from the controller.
After the access point boots and receives a configuration file, the LED continues to
flash alternately green and amber until a radio is enabled.
On. The access point is powered on and is operational.
On. The access point has not been configured and is not operational.
Copyright © 2011, Juniper Networks, Inc.