Clearing Inactive Configurations - Cisco Nexus 9000 Series Configuration Manual

Working with Configuration Files
After you enter the write erase command, you must reload the ASCII configuration twice to apply the
Note
breakout configuration.
Procedure
Step 1

Clearing Inactive Configurations

You can clear inactive QoS and/or ACL configurations.
Procedure
Step 1
Step 2
Command or Action
write erase [boot | debug]
Example:
switch# write erase
Warning: This command will erase
the startup-configuration.
Do you wish to proceed anyway?
(y/n) [n] y
Command or Action
show running-config type inactive-if-config
Example:
# show running-config ipqos
inactive-if-config
clear inactive-config policy
Example:
# clear inactive-config qos
clear qos inactive config
Inactive if config for QoS manager is
saved
at/bootflash/qos_inactive_if_config.cfg
for vdc default
you can see the log file @ show
inactive-if-config log
Cisco Nexus 9000 Series NX-OS Fundamentals Configuration Guide, Release 7.x
Clearing Inactive Configurations
Purpose
Erases configurations in persistent memory. The default
action erases the startup configuration.
The boot option erases the boot variable definitions and the
IPv4 configuration on the mgmt0 interface.
The debug option erases the debugging configuration.
The running-configuration file is not affected by
Note
this command.
Purpose
(Optional)
Displays any inactive access control list (ACL) or
quality of service (QoS) configurations.
The values for the type argument are aclmgr and
ipqos.
• aclmgr—Displays any inactive configurations
for aclmgr.
• ipqos—Displays any inactive configurations
for qosmgr.
Clears inactive configurations.
The values for the policy argument are qos and acl.
The following describes the values:
• qos—Clears inactive QoS configurations.
• acl—Clears inactive ACL configurations.
• acl qos—Clears inactive ACL configurations
and inactive QoS configurations.
125