Keg - BREWART BEERDROID Operating Manual

Keg

The Keg Zone brings your brew to
optimum temperature for kegging or
bottling, this is pre-set to 18°C (64°F) for
ale and lager programs. In a custom
program it will be the temperature you
set manually.
The display screen will
k
indicate brewing complete.
The display screen will read:
k
preparing to keg, please wait.
When the brew is within 1°C
(2°F) of this target temperature,
it will read: ready to keg.
The temperature displayed
k
on the screen indicates the
current brew temperature
When your BeerDroid indicates
k
ready to keg, press
program on the control panel.
This will end the current program.
Turn unit off at the rear
k
power switch.
Keg or bottle your beer.
k
 Note
Before Kegging or Bottling we
recommend pouring a small
amount of brew (100ml or
less) into a glass through the
tap. Smell and taste the brew
sample to ensure brew quality.
to end

BEERDROID INSTRUCTIONS
End of Fermentation
(EOF) not detected
If eof has not been detected during the
ferment zone then:
eof not detected will appear
k
on the display screen, and
check the sg then press
k
resume or to end program

in the user prompt panel.
End of fermentation will need to be
tested manually with a hydrometer over
two consecutive days to determine
if fermentation is complete – go to
brewart.com/101 for information on
how to use a hydrometer when EOF is
not detected.
If no action is taken within 2 days in the
keg zone the unit will automatically
move to the store zone. Your brew can
safely stay in the store zone until you
are ready to keg.
 Note
If your BeerDroid is configured
for Wi-Fi operation, you may
transition between the store
zone and the keg zone at any
time by using the BrewArt app.
 Note
If you have manually transitioned
the unit from store to keg, it
will not automatically transition
to store again.
to

19