Ruijie Networks RG-S2600E Series Cli Reference Manual page 879

S2600E CLI Reference Guide
1
For IDs used in the following commands, refer to the command ID table below:
ID
ID
name
sn
start-sn
inc-sn
deny
permit
port
interface idx
src
src-wildcard
src-ipv6-pfix
dst-ipv6-pfix
pfix-len
src-ipv6-addr
dst-ipv6-addr
dscp
Chapter 1 ACL Configuration Commands
ACL
Commands
Meaning
Number of access list. Range:
Standard IP ACL: 1 to 99, 1300 to 1999
Extended IP ACL: 100 to 199,2000 to 2699
Extended MAC ACL: 700 to 799
Extended expert ACL: 2700 to 2899
ACL name
ACL SN (products can be set according to the priority)
Start sequence number
Sequence number increment
If matched, access is denied.
If matched, access is permitted.
Protocol number. For IPv6, this field can be IPv6, icmp, tcp, udp
and numbers 0 to 255. For IPv4, it can be one of eigrp, gre, ipinip,
igmp, nos, ospf, icmp, udp, tcp, and ip, or it can be numbers 0 to
255 that represent the IP protocol. It is described when some
important protocols, such as icmp/tcp/udp, are listed individually.
Interface index
Packet source IP address (host address or network address)
Source IP address wildcard. It can be discontinuous, for example,
0.255.0.32.
Source IPv6 network address or network type
Destination IPv6 network address or network type
Prefix mask length
Source IPv6 address
Destination IPv6 address
Differential service code point, and code point value. Range: 0 to
63
Configuration