Table of Contents
Advertisement
1. Setup Method
Reset by pressing the 'VOL UP' key and 'SCRN" key.
2. Details
Includes all items applicable to the supported NA-R300 remote control unit.
Function
Autodimmer
The dimmer responds with the same timing (without waiting) as external light changes
Video source
Following power on, the video source is TV (VIDEO1 for the W market sector)
The video source can be changed with the remote control BAND key.
The AVIN1 and 2 settings are for VIDEO.
Wide mode
Full
Touch adjust
The touch adjust screen is recalled with the remote control SRC key.
The SET UP screen touch adjust allows the touch panel reference points (2 points)
to be written to E2PROM. Proper completion of writing to the E2PROM is followed by
two beeps. The occurrence of an error results in four beeps. The data remains even
if test mode is reentered.
During touch response a + cursor is displayed for both NTSC and full screen.
When navi supporting wide mode is connected, the navi screen displays the navi
transmission X, Y coordinates in numerals.
FM-TX
The remote control MODE key allows ON/OFF switching (normally ON).
One click allows cycling between Full Down ↔ Center ↔ Full Up
Image quality
adjustment
Irrespective of video source, set the contrast curve in the range 0.0~2.5~5.0[V]
Beep
For even overseas models a single press causes a beep (Same as J).
TV Tuner
Seek mode is AUTO1
Following power on displays 9CH (J), 11CH (K/H), 9CH (M:CHINA).
Updates TV1 preset channels with dedicated test mode initialization values.
The remote control VOL UP key recalls the TV AREA setup screen.
The remote control VOL DOWN key changes the TV AREA.
The remote control ten key pad allows recall of preset CH (same as normal operation).
The remote control TV/NAVI key allows diversity adjustment mode On/Off.
3. Termination Method
Reset terminates test mode, and sets all values to initialization values
(except for data adjusted with the test mode touch adjust etc.)
TEST MODE
Operation details
LZ-800W
11
Advertisement
Table of Contents
