Advertisement
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the use r's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of th e FCC Rules. These limits are
designed to provide reasonable protection against h armful interference in a
residential installation. This equipment generates , uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to rad io communications.
However, there is no guarantee that interference wi ll not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by tu rning the equipment off and
on, the user is encouraged to try to correct the in terference by one or more of the
following measures:
� Reorient or relocate the receiving antenna.
� Increase the separation between the equipment and r eceiver.
� Connect the equipment into an outlet on a circuit d ifferent from that to which
the receiver is connected.
� Consult the dealer or an experienced radio/TV techn ician for help .
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions : (1) this device may not cause harmful interference, and
(2) this device must accept any interference receiv ed, including interference that
may cause undesired operation.
Shielded cables must be used with this unit to ensu re compliance with the Class
B FCC limits.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the transmitter
by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur
radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inf
érieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique à l'intention des autres utilisateurs, il
faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonn
ée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement
d'une communication satisfaisante.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autoris é e aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Advertisement
