Engine Oil - MOTO GUZZI BELLAGIO Service Station Manual

Hide thumbs Also See for BELLAGIO:
Table of Contents

Advertisement

BELLAGIO
Replacement
CAUTION
THE UNIT MUST BE HOT WHEN THE OIL IS CHANGED AS UNDER SUCH CONDITIONS OIL IS
FLUID AND THEREFORE EASY TO DRAIN.
NOTE
RIDE SOME km (miles) TO WARM UP ENGINE OIL
Place a container with + 400 cm³ (25 cu in) capacity under the drainage plug (3).
Unscrew and remove the drainage plug (3).
Unscrew and remove the breather cap (2).
Drain the oil into the container; allow several minutes for oil to drain out completely.
Check and if necessary, replace the sealing washer of drainage plug (3).
Remove any metal scrap attached to the drainage plug (3) magnet.
Screw and tighten the drainage plug (3).
Pour new oil through the fill opening (1) until it reaches the cap/dipstick hole (1).
CAUTION
DO NOT ADD ADDITIVES OR ANY OTHER SUBSTANCE TO THE FLUID. WHEN USING A FUNNEL
OR ANY OTHER ELEMENT, MAKE SURE IT IS PERFECTLY CLEAN.
Screw and tighten the caps (1 - 2).

Engine oil

Check
CAUTION
ENGINE MUST BE WARM TO CHECK ENGINE OIL LEVEL.
NOTE
DO NOT LET THE ENGINE IDLE WITH THE VEHICLE AT STANDSTILL TO WARM UP THE ENGINE
OIL AND REACH THE OPERATING TEMPERATURE OF ENGINE OIL. OIL IS BEST CHECKED
AFTER RUNNING FOR ABOUT 15 KM (10 miles).
Shut off the engine.
Keep the vehicle upright with the two wheels on the ground.
Unscrew and remove the dipstick (1).
Clean the dipstick (1).
Reinsert the dipstick (1) into the opening but do not screw it.
Maintenance
MAIN - 29

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BELLAGIO and is the answer not in the manual?

Questions and answers

Table of Contents

Save PDF