Controlled Mode; Autonomous Mode - Colubris Networks MARP-330r Quick Start Manual

Table of Contents

Advertisement

Controlled and Autonomous modes
The MAP-330R supports two modes of operation: controlled mode and autonomous mode.

Controlled mode

Controlled mode is the default operating mode for the MAP-330R when
shipped with 5.1 firmware and higher. It lets you take advantage of
centralized management and plug-and-play installation.
When operating in controlled mode:
• The MAP-330R must be installed in conjunction with an MSC-5000
series service controller.
• The MAP-330R's management tool will not allow local configuration
changes. The MAP-330R must be configured and managed through
the service controller's management tool. For more information see
the MSC-5000 Series Administrator's Guide.
Controlled MAP-330R initial configuration
When operating in controlled mode, initial configuration of the MAP-330R is not required. Simply power it up and connect it to a network that provides
access to an MSC-5000 series service controller. Once the MAP-330R connects with the service controller, its firmware and configuration settings will
be updated if required.
Note: A MAP-330R operating in controlled mode must obtain its IP address from a DHCP server. Ensure that a DHCP server is available on the
network, or that an MSC is configured to operate as a DHCP server. To configure an MSC to act as a DHCP server, on the MSC in the left pane select
Service Controller, and then in the right pane select Network > Address allocation.
To power-up the MAP-330R, connect an 802.3af PoE power source. The MAP-330R is fully operational when the power light stops flashing.
4 of 6

Autonomous mode

In autonomous mode, the MAP-330R operates as an independently
managed access point, just as in software releases prior to 5.1.
This means:
• The MAP-330R is managed and configured locally.
• Centralized management and monitoring via an MSC-5000 series
service controller are not available.
Important: If you upgrade a MAP-330R from a software release prior to 5.1, it
starts up in autonomous mode.
42-11-0330-09

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MARP-330r and is the answer not in the manual?

Questions and answers

Table of Contents