Page 1
Hola, me llamo Sunny CS, calefactor de cuartos de niños con sensores de Hola, me llamo Sunny CS, calefactor de cuartos de niños con sensores de temperatura cribside™. Bonjour, je suis le ventilateur chauffant Sunny CS, doté du détecteur de...
Page 2
Welcome to Vornadobaby Thank you for choosing to put a Vornadobaby product in your nursery. Our goal is to provide healthy, comfortable air - through every season. Vornado has been doing this for quite a while now. We’ve brought all our experience in air health and comfort, and tailored it exclusively for your nursery.
Safety ......................8 Sunny CS Controls ................... 9 Plug In & Placement ................10 How To Use ..................... 12 Crib Sensor Remote ................15 Keeping Sunny CS Clean ..............18 Tips ......................19 Troubleshooting ..................20 Warranty ....................22 Español p. 23 Français p.
READ ALL INSTRUCTIONS BEFORE shock and injury to persons, observe the following: - A heater has hot and arcing or sparking parts inside. Do not USING THIS HEATER use it in areas where gasoline, paint, or flammable liquids are IMPORTANT SAFETY INSTRUCTIONS used or stored.
Page 5
crimped or closed in doors. Place appliance near an easily circular saw is not advised. Do not use this heater with a timer accessible outlet so the product can be unplugged quickly designed to automatically turn the unit on or off, as this may during an emergency.
Page 6
SERVICING WARNING — To reduce risk of fire, electrical shock permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded and injury to persons, observe the following: receptacle is available. - Clean your product regularly, only as is instructed in this manual.
(2) l’utilisateur de l’appareil batteries. doit accepter tout brouillage radioélectrique subi, même si le - Do not leave batteries in your Sunny CS remote for long brouillage est susceptible d’en compromettre le fonctionnement. periods of non-use.
Safety Plug It In Safely! Your Sunny CS has a 6 ft. power cord, covered for additional safety. Vornado recommends placing product as close to an outlet as possible and securing the remaining cord. Locking Controls 2 Stage Overheat Safety...
Keep Your Smoke Alarms in Good Working Order! Be sure your smoke alarms are installed, tested and working according to its Note: Place power manufacturer’s standards. cord through slotted opening on bottom of Sunny CS to ensure stability of heater. 10 English...
Page 11
Set Up 1. Position Sunny CS so the vortex beam of air is directed across the room, unobstructed. 2. Plug power cord into grounded wall outlet. Safety Tip: It is best to position Sunny close to the power outlet and store excess power cord inside the Power Cord Storage.
How To Use Operation 3. For fan use only without heat, select Fan Only (FA) on the Heat setting. The Control Panel 1. Press Power button On ( ). The red light and display will turn blue. Control Panel will illuminate when On. The Control Panel will dim after approximately 20 seconds.
Page 13
5. The Actual temperature will display the room Note: Previous control settings are kept for the temperature. The Set temperature will display next time the unit is powered On, unless unit is the desired temperature setting. unplugged or tipped over. 6.
Page 14
2. To turn this feature Off press and hold the Control Lock button ( ) for 3 seconds. keeping the heater in parents’ desired setting. Note: If Sunny CS is tipped over, all power will Locking Controls automatically shut-off. The Control Lock feature 1.
To keep your baby comfortable, use the wireless Crib Sensor Remote (CSR). The CSR will sense the temperature at its location, up to 15 feet away from Sunny CS. On the control panel, the Actual temperature will display the approximate temperature of the room at the location of the CSR.
Page 16
3. The CSR is linked when the green light 2. If CSR is Off or not within range of Sunny CS remains On and the LCD Screen displays the the green light will not be illuminated and the word “remote”. For accuracy Sunny CS will ( ) icon will appear on the LCD Screen.
Page 17
Crib Sensor Remote Placement 1. Attach the CSR to the crib or place the CSR near the crib, but out of reach from child . The CSR will now monitor the selected Heat setting. DO NOT PLACE CSR IN CRIB English...
Note: Do not use gasoline, thinners, solvents or other chemicals for cleaning. Always unplug Sunny CS before starting any part of the cleaning process. 18 English...
• Always set Power Button to Off and unplug Note: If the safety shut-off system repeatedly shuts off Sunny CS or if it will not reset, DO Sunny CS before cleaning. • Cover, or place Sunny CS back into retail NOT ATTEMPT TO DISASSEMBLE SUNNY CS.
Troubleshoot Unit fails to Unit is not plugged in. Plug Power Cord into electrical outlet. power on. Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker / ground fault interrupter, or replace fuse (See TIPS). The unit has overheated.
Page 21
Unit power on Power off and unplug the unit. On the bottom of the unit, there is a gray tip over switch. Push in 4-5 times ensuring it is not stuck. Set unit but there is no down on flat surface. Be sure power cord is not under unit. Plug unit in heat.
If you’re not satisfied with this product, let us know. We’ll go the extra mile to ensure you’re a happy Vornadobaby parent! Vornado Air LLC (“Vornado”) warrants to the original consumer or purchaser this Vornadobaby® Sunny CS Nursery Heater (“Product”) is free from defects in material or workmanship for a period of five (5) years from the date of purchase.
Page 23
Speak your mind vornadobaby.com/reviews Hable con franqueza vornadobaby.com/reviews Exprimez-vous! www.vornado.com/reviews Vornado Air, LLC 415 East 13th Street, Andover, Kansas 67002 800.234.0604 vornadobaby.com support@vornadobaby.com CL3-0366 RA, V00...
Need help?
Do you have a question about the Sunny CS and is the answer not in the manual?
Questions and answers