Networking The Rml-Series Mixer; Ip Address Modes; Wired Ethernet Control Setup - PRESONUS StudioLive RML16AI Quick Start Manual

2.0

Networking the RML-series mixer

2.1

IP Address Modes

2.0 Networking the RML-series mixer
2.1 IP Address Modes
Meters
Meters
+48V
+48V
Cue
Mute
Cue
Mute
All
Main
All
Main
2.2

Wired Ethernet Control Setup

8 9
8 9
8
8
An IP Address a unique string of numbers that identifies each computer
or device using the Internet Protocol to communicate over a network.
StudioLive RM Mixers support three IP Address modes.
Dynamic
This is the most common and the default setting for StudioLive devices. In dynamic
mode, the mixer is assigned an IP Address by a DHCP server which is included in
most routers. When a mixer comes online, the router sees it and assigns a unique IP
Address. The mixer will continue to wait for a DHCP server to provide an address.
Static Self Assigned
This mode is used if you're doing a direct connection between the mixer and
another device like an AI Console mixer or CS18AI without the use of a router. In
this mode the mixer will assign itself an IP Address based on a compatible range.
Static Manual
This mode is typically reserved for more complex networking installations and
is usually setup by an IT professional. In this mode you can manually assign an
IP Address, Subnet Mask, and Gateway. Please consult your IT Administrator
before attempting to configure a Static Manual IP Address Mode.
Setting up the IP Address modes can be done in the Settings view
Phones
of UC Surface in the Network tab. Alternatively, you can change the
Phones
IP Address modes during bootup with the following method.
Hold down the Cue Source button while booting the mixer to reset from Static/
Self-assigned to Dynamic mode - (The LED meters will flash Yellow to indicate the
mode has been changed)
Hold down the Main Source button while booting the mixer to reset to Self-assigned
IP - (The LED meters will flash Red to indicate the mode has been changed)
10 11
10 11
Your StudioLive RML32AI and RML16AI can be set up for control with
a wired Ethernet connection in seconds. Simply connect the included
Ethernet cable to the Ethernet control port on the back of the mixer and
to a network router that is also connected to your computer or iPad.
When you launch UC-Surface with the computer or iPad and
StudioLive RML32AI or RML16AI connected to the same network,
the software should automatically see the mixer.
Tape In
Tape In
L
L
R
R
-80 +6
Level
-80 +6
Level
12
12
Ethernet Cable
StudioLive RML-Series
™
Owner's Manual
Mono Out
Mono Out
13 14
13 14
-80 +6
Level
-80 +6
Level
15
15
4