Ignition Steering Lock - MZ 125 SX Repair Manual

.
-~
G.lt1
Lighting/Signal System
3. Unscrew the two hexagon nuts M6 beyond the rear wheel
mud guard, remove the sleeves and the washers.
4. Remove the rear light, inspect and replace, if necessary.
5. Disconnect the terminals.
6. Inspect the rubber seal, replace if necessary.
Note:
Make note of the cable connection locations.
Danger of short-circuits! The terminals must not touch each
other.
Installation
1. Insert the rubber seal.
2. Mount the taillight housing and screw it on.
3. Check the terminals and clean if necessary.
The ends of the cable must be clean and tightly clamped in.
4. Connect the cable.
5. Insert a bulb.
6. Screw on the light emission lens.
7. Perform a function test.
3.5.6 Ignition Steering Lock
"
Every lock has a code number used by MZ to manufacture new
keys.
If this code number is no longer available, providing the VIN
(Vehicle Identification Number), located on the right side of the
steering head pipe) will make it possible for MZ to create a new
key.
Lock maintenance
The ignition steering lock must be treated with a suitable care
agent, depending on the usage conditions.
A frozen lock must be thawed before use. Otherwise the key may
break off.
MZ 125 $XlSM Repair Manual
05/02 33