LK Systems Minishunt M60 Assembly Instructions Manual

LK Minishunt M60
3
1
2
4
5
7
8
Design
The LK Minishunt M60 is intended for use in
smaller under floor heating areas (up to 60 m² de-
pending on heating requirements/laying proce-
dures etc.) and is connected to an existing heating
system. The shunt unit consists of an automatic
speed-controlled circulation pump for the under
floor heating circuit, a maximum limit function
for the feed temperature, a return valve for the
under floor heating circuit, a fill/discharge and
air bleed valve plus a thermostatic valve unit, fit-
ted with a thermostat and a sensor, connected to
a capillary tube.
Connectors for a under floor heating circuit and
mini manifolds for 2, 3 or 4 under floor heating
circuits are provided as accessories. Possible pipe
connections for floor heating are dim. 8, 12, 16
and 20 mm. The installation can be concealed in
built-in or wall-mounted cabinets, see heading
Installation cabinets.
1. Thermostat valve.
2. Switching between single or twin pipe
radiator systems and shutting-off against
the return connection of the primary side.
When delivered, the minishunt is set for a
twin pipe radiator system with the outer
hex-screw spindle (dim. 10 mm hex.) scre-
wed in and the inner hex-screw spindle
(dim. 4 mm hex.) screwed out. For single
pipe systems the outer hex-screw spindle is
gradually screwed out until correct
9
10 6 14
temperature is achieved to the radiators.
Shutting-off against the return connection
of the primary side is achieved by turning
closed the outer and then the inner hex-
screw spindle.
3. Thermostat with capillary tube connected
sensor, length 2 m.
4. Feed connection from the primary side, ¾"
male EuroCone. Connectors for 15 mm Cu
are supplied.
5. Return connection to the primary side, ¾"
male EuroCone. Connectors for 15 mm Cu
are supplied.
6. Temperature limiter. Maximum limiter of
the feed temperature to the under floor
heating.
7. Return valve (dim. 8 mm hex.).
8. Connection ½" female thread for system
refill upon installation.
9. Ventilation valve with hose nipple.
10. VF valve (dim. 8 mm hex.). Must only be
used for installations with low available
drive pressure from the circulation pump of
the primary side.
11. Circulation pump, Wilo Yonos Para
RSB15/6-RKA with automatic speed con-
trol.
12. Connection feed floor heating ½" female
thread.
13. Connection return floor heating ½" female
thread.
14. Bracket
Assembly instructions | LK Minishunt M60
11
12
13
EN.33.C.134.1512
1 (8)