Connecting The Hc900 Controller To A Pc With The Designer Software - Honeywell HC900 User And Installation Manual

Connecting the HC900 Controller to a PC with the Designer Software

To establish communications between the HC900 controller and the Process Control (HC) Designer
configuration software use any of the following methods.

A. Direct Serial RS-232 connection. See page 133. Direct with RS-485 and RS-485 to USB converter
with supplied instructions.

B. Modem connection. See page 136.

C. Direct Ethernet connection. See page 149.

D. Networked Ethernet connection. See page 150.
These methods are described below.
ATTENTION:
Always observe the wiring/cabling guidelines on page 54.
132 HC900 Process & Safety Controller User and Installation Manual Revision 6
21 April 2017