CO/Tech 36-4272 Instruction Manual

4 W LED Work Light
Art.no 36-4272
Please read the entire instruction manual before using the product and
then save it for future reference. We reserve the right for any errors in
text or images and any necessary changes made to technical data.
In the event of technical problems or other queries, please contact
our Customer Services.
Safety
• Do not subject the light to knocks or shocks.
• The light bulb cannot be replaced.
• This product must not be dismantled or modified in any way.
• Do not use the product if it or its charger is damaged in any way.
• Only use the supplied charger cables.

Operating instructions

Charging
Note: Charge the light for 6–8 hours before using it for the first time.
Switch the light off before charging it.
230 V
The AC/DC mains adaptor has
an interchangeable plug for use
in different European countries.
To change the plug:
1. Press in the spring catch
and detach the plug from
the adaptor.
2. Slide the new plug
onto the adaptor until
the spring catch locks it
in place.
3. Connect the 230 V mains adaptor to the light and then plug it into
an electrical socket.
4. The LED indicator shines red when the light is being charged and
changes to green when the battery is fully charged.
5. Unplug the mains adaptor from the power point when the battery
is fully charged.
GREAT BRITAIN • CUSTOMER SERVICE tel. 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet www.clasohlson.co.uk
12 V
1. Connect the 12 V charger cable to the light and then plug it into
the 12 V socket.
2. The LED indicator shines red when the light is being charged and
changes to green when the battery is fully charged.
3. Unplug the charger cable from the power point when the battery
is fully charged.

Care and maintenance

• Clean the product using a lightly moistened cloth. Use only mild
cleaning agents, never solvents or corrosive chemicals.
• If the light is not to be used for a long time, the battery should be
fully charged every 4 to 5 months to prolong its capacity.
Disposal
This product should be disposed of in accordance with local regulations.
If you are unsure how to proceed, contact your local council.

Specifications

LED 4 W COB
Luminous flux 200 lm
IP rating IP20
Rechargeable battery 7.2 V/900 mAh, NiMH
Mains adaptor In: 100–240 V, 50–60 Hz
Out: 12 V DC, 300 mA
Charging time 3–5 hours (6–8 hours before initial use)
Operating time Approx 3 hours
Operating temperature −5 to 40 °C
Size Ø 57 mm, height: 410 mm
Weight 350 g

Troubleshooting guide

The light does not The battery is flat, charge it.
come on, the LED
indicator does not
flash blue.
The light won't 12 V
charge. The LED • Is the charger cable undamaged and
doesn't come on. securely connected to both the 12 V
socket and the light?
• Check that the 12 V socket is live.
Sometimes the vehicle ignition needs
to be switched on in order for the 12 V
socket to be live.
• The plug of the cable contains a 2 A fuse
(20 × 5 mm), check the fuse and change
it if necessary.
• This is how to do it:
1. Unscrew the cap of the plug and remove
the fuse.
2. Replace the fuse with a new one.
3. Screw the cap back on.
230 V
• Is the mains adaptor undamaged and
securely connected to both the electrical
socket and the light?
• Is the electrical socket is live?