Hayward SP0710XR50 Owner's Manual

VariFlo
GENERAL
1. Proper fitting make-up is hand tight plus one to 1-
1/2 turns maximum. Always use Teflon pipe tape
or Permatex No.2 for connections to provide a
good, "living" seal.
IMPORTANT: Do not over tighten pipe fittings.
2. SERVICING VALVE: If it becomes necessary to
service or gain access to the key or valve seat
gasket:
a. Set handle in "Winterizing" position.
b. Remove cover screws.
c. Lift cover and key assembly out.
3. RE-ASSEMBLY VALVE:
a. Wipe debris from cover 0-ring.
b. Set handle in a "Winterizing" position. Align
flat edge on cover with body. Press down to
seat assembly.
c. Secure assembly to body with cover screws
and nuts. Tighten cover screws evenly and
alternately.
Do not over tighten.
CAUTION –Spring
Hazard
– Release of
Valve spring
compression can
cause personal injury.
To avoid, only remove
handle pin if servicing
key O-ring. Remove
handle pin before
slowly removing Cover
screws in an alternate
pattern.
WARNING
-
Failure to follow instructions can cause severe injury and/or death.
®
1 1/2" Filter Control Valve
Owner's Manual
Model: SP0710XR50 (DE Filters)
VALVE SETTING
Read and follow all instructions
Hayward Pool Products
620 Division Street, Elizabeth, NJ 07207
Phone: (908) 355-7995
WWW.HAYWARD.COM
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Multiport
TURN OFF PUMP BEFORE CHANGING VALVE POSITION
FUNCTIONS OF VALVE POSITIONS
PUMP - BOTTOM - THROUGH FILTER - TOP - RETURN
FILTER
For normal filtration and vacuuming pool through
filter.
PUMP - TOP - THROUGH FILTER - BOTTOM - WASTE
BACKWASH
For cleaning filter.
PUMP - BOTTOM - THROUGH VALVE - WASTE
RINSE
For initial start-up and clearing valve of debris after
backwashing.
PUMP – THROUGH VALVE - WASTE
WASTE
For vacuuming directly to waste, lowering pool level
and/or draining pool.
NO CIRCULATION PAST PUMP PORT
CLOSED
For shutting off all flow to filter and pool.
PUMP – THROUGH VALVE - RETURN
RECIRCULATE
For bypassing filter, but circulating pool water.
Drain and winterize filter and pump per manufacturer's
WINTERIZING:
instructions. To drain water from VariFlo® Multiport
valve—depress and rotate valve handle and place
handle pointer between any detente positions.
REF
PART NUMBER
NO.
1 SPX0710XF
2 SPX0710XZ7
3 SPX0710Z16
SPX0710G
4 SPX0710Z1A
5 SPX0710xZ5
6 SPX0603S
7 SPX0710Z62
8 SPX0735GA
SPX0710K
9 SPX0710XD
10 SPX0710xC
11 SX200Z4PAK2
SPX0710BA17
12 SPX0710MA
SX200Z9
SPX0710XR50AA
in this owner's manual and on the equipment.
IS0710XR50 REV B
FLOW DIRECTION THROUGH VALVE
DESCRIPTION
Handle, Standard
Pin, for Handle
Non-Metallic Bearing (Pack of 5)
Valve Position Label
Cover screw set with nuts (Set of 6)
Cover O-ring
Spring
Spring Washer Set (Set of 2)
O-ring & TFE Shaft seal set
¼" Plastic Pipe Plug
Valve Seat Gasket
Key
Valve O-ring (Set of 2)
Key, Cover and Handle Assy
Sight Glass with Gasket
Gasket for Sight Glass
Valve body with gasket and piping
NO.
REQ'D
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1