Charging Lithium Battery In The Balance Mode - KDS POWER RC-6S Manual

SAFE TIMER CALCULATION
LiPo BALANCE
2.0A 11.1V (3S)
DE C IN C DEC IN C
Start
Batt Type
Enter '>3 seconds'
Stop
R:3SER S:3SER
CONFIRMC(ENTER)
Start
Enter
Li3S 1.2A 12.59V
BAL 022:43 00682
Number
Charging Battery
Charged
of cells time Voltage
capacity
Charging
current

Charging lithium battery in the balance mode

This function is for balancing the voltage of Lithium-polymer battery cells while charging.
In the balance mode, the battery needs to have a balance lead to connect the individual
port at the right side of the charger. And you need to connect the battery's out put plug to
the output of charger.
Charger in this mode is different from the normal modes, because the built-in processor
monitors voltage of individual cell and control input current fed into each cell to normalize
the voltage.
The left side of the first line shows the type of battery you
choose.The value on the left of the second line of the charger is
current user set. After setting the current and voltage, press
process. (charge current: 0.1-5.0A, voltage:1-5V)
This displays the number of cells you set up and the processor
detects. "R"shows the number of cells detected by the charger
and "S" is the number of cells set by you at the previous screen.
If both numbers are identical you can start charging by press
START/ENTER button. If not, press BATTERY/STOP button to
go back to previous screen to carefully check the number of
cells of the battery pack before going ahead.
This screen shows the real-time status during charge process.
Press BATTERY/STOP key once to stop the charge process.
15