Test Program 1301.Exe; Introduction; Figure 4-1: Location Of Major Components - Philips ISP1301 User Manual

Philips Semiconductors

5. Test program 1301.EXE

5.1.

Introduction

A DOS test program "1301.exe" is provided to help you verify the functions of the ISP1301 chip. The program
uses the PC parallel port to access the ISP1301 registers through the I
2
software I C master at the hardware abstraction layer (HAL).
The test program can do the following:
2
Set the I C slave address for the ISP1301 based on the hardware setting of the ADR pin
Reset all registers to their default values
Display the current value of all registers on your PC screen
Write any value to a writable register
Set the mode of operation of the ISP1301 (such as, USB function and suspend mode, transparent I
mode, transparent general-purpose buffer mode, and global power-down mode)
Enable or disable the charge pump of the ISP1301.
UM10028_1
User's Guide
JP3
JP5
J12
J8
J13
U4

Figure 4-1: Location of major components

Rev. 1.0—February 2003
ISP1301 USB OTG Transceiver Eval Kit User's Guide
J10
JP4 J11
JP2
J3
SW1
ISP1301 EVALUATION BOARD
2
J6 J7
J
5
U1
REV 1.0
C interface. The program simulates
© Koninklijke Philips Electronics N.V. 2003. All rights reserved.
J9
J1
J4
2
C
8 of 18