Replace Fuser - Xerox Phaser 6180 Service Manual
Color
Hide thumbs
Also See for Phaser 6180:
- User manual (158 pages) ,
- Quick use manual (6 pages) ,
- Specifications (4 pages)
Table of Contents
Advertisement
Error Messages and Codes
Replace Fuser
Applicable Chain Link
Initial Action
3-34
The Fuser has reached its end of life.
Warning
The Fuser may be hot. Turn the printer power Off and allow at least 5
minutes for the Fuser to cool before removing the Fuser.
■
Chain Link
010-351: Replace Fuser
■
Check the Fuser life using CentreWare IS.
■
Cycle printer power.
■
If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL6.1.10
■
MCU Board, PL9.1.20
■
Troubleshooting Procedure Table
Step
Actions and Questions
Check the Fuser life using CentreWare IS.
1
Does the Level show 0%?
Is the Fuser correctly installed?
2
3
Does the error still occur?
4
Replace the Fuser (page 8-10). Does the
error still occur?
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
■
page 10-10
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Fuser" on page 10-46
■
Yes
Replace the
Fuser
(page 8-10).
Go to step 3.
Go to step 4.
Replace the
MCU Board
(page 8-87).
Phaser 6180 Color Laser Printer Service Manual
No
Go to step 2.
Reseat the
Fuser.
Complete.
Complete.
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Phaser 6180 and is the answer not in the manual?
Questions and answers
Yellow ink is leaking onto my documents. Is there a way to print by removing the yellow ink cartridge?
blinking green and stays at configuration page. Does print page. If you cancel it gets stuck at cancelling job and never goes from that screen. Powering off for a while and turning back on with same results. Can not set nvram through menu as it says it has a job that is currently running.