Related Manuals for XMODS 6000938
Summary of Contents for XMODS 6000938
- Page 1 STARTER KIT USER’S GUIDE PRECISION CONTROL! Page 9. The 6000938 XMODS Starter Kit revs up your XMODS experience. 1:16 SCALE Please read this user’s guide before building and using your new car. AGE 8+...
-
Page 2: Table Of Contents
Contents XMODS Custom RC Starter Kit .............................3 Installing Car Batteries ..............................4 Using AA batteries (not included) ..........................4 Using a 9.6V Ni-MH battery (not included) ......................4 Install the Controller Battery ............................5 Assembling Your XMODS Custom RC ........................6 Assembling the Car Chassis............................6 Pairing Your Controller and the Car ........................7... -
Page 3: Xmods Custom Rc Starter Kit
• Digitally proportional steering for optimal speed, acceleration, and maneuverability. To really get your motor running, customize your XMODS with optional upgrades for both performance and looks, available at your local RadioShack store. Check out the line-up of XMODS upgrades available online at www.RadioShack.com. -
Page 4: Installing Car Batteries
Installing Car Batteries There are two ways to power your vehicle using either 6 AA batteries or a rechargeable Ni-MH battery (neither included) Using AA batteries (not included) 1. Make sure the power switch on the chassis is OFF. 2. Unlock the battery cover to open the battery box. 3. -
Page 5: Install The Controller Battery
5. Reassemble the front and rear unit to battery base according to “Assembling the Car Chassis on page 6. Install the Controller Battery Your controller needs a 9V battery (not included). We recommend 9V alkaline batteries for best performance. If the LED is off or the range of your car decreases, replace the battery. 1. -
Page 6: Assembling Your Xmods Custom Rc
2. Connect the terminal of the rear unit to the terminal of the battery unit, and secure them with two screws. Note: When updating your car with new rubber tires, to run smoothly make sure you fit the tires aligned with the XMODS logo facing on the outside. XMODS logo... -
Page 7: Pairing Your Controller And The Car
ON/OFF LED Indicator Pairing Your Controller and the Car Your XMODS operates at a frequency of 2.4Ghz. Before driving for the first time, you must pair the controller and car. The pairing Controller should be made before mounting the body. -
Page 8: Mounting The Car Body On The Chassis
Mounting the Car Body on the Chassis Recommended Decal Placement 1. Fit the body on the 2 poles. 2. Fix the body on the chassis with the 2 body pins. Body pin Body pole... -
Page 9: Driving Your Car And Adjusting Trim
Driving Your Car and Adjusting Trim After you turn on both controller and car, squeeze the trigger to move forward and push the trigger away from the handle to go in reverse. If your car does not drive straight when you release the steering wheel, determine if the car steers too far right or left, and then adjust the trim: 1. -
Page 10: When You Finish Driving
Note: • Running your XMODS continuously for long periods can generate high heat levels. If the car overheats, its overheat protection will stop the car. In this case, switch the controller and the vehicle off and allow to cool down before resuming operation. -
Page 11: Xmods Upgrades
Xmods Upgrades Installing the 4WD Unit 1. Remove the front unit from the main control unit of the chassis. 2. Remove the rubber tires from the Starter Kit and install them onto your new 4WD unit. 3. Insert the center shaft, and then connect the 4WD unit to the main control unit and then secure it with the screws. -
Page 12: Fcc Information
FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. - Page 13 or lightning), or excess voltage or current; (b) damage or failure caused by loss of control, loss of signal between the toy and its controller due to excessive range or low power, impact, violent contact, collision or rough use; (c) improper or incorrectly performed repairs by persons who are not a RadioShack Authorized Service Facility;...
- Page 14 Complies with the European Union’s “Restriction of Hazardous Substances Directive,” which protects the environment by restricting specific hazardous materials and products. XMODS is a trademark used by RadioShack Corporation. 08A13 ©2013. RadioShack Corporation. All rights reserved. 6000938 RadioShack is a registered trademark used by RadioShack Corporation.
Need help?
Do you have a question about the 6000938 and is the answer not in the manual?
Questions and answers