Table of Contents
Advertisement
(3)
Remove 1 screw and take off the finisher board access cover.
(4)
Release the latches and take off the rear lower cover of the hole punch unit.
(5)
Remove 3 screws and take off the rear cover of the hole punch unit.
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C
FIRMWARE UPDATING
Board access cover
Fig. 8-39
Rear lower cover
Fig. 8-40
Rear cover
Fig. 8-41
8 - 44
© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Advertisement
Table of Contents
